Deye SUN-70K-SG02HP3-EU-EM6 handleiding
Handleiding
Je bekijkt pagina 20 van 63
- 18 -
Safety Hint:
Please use approved DC cable for PV system.
Cable type
Range Recommended value
Cross section（mm ）
Industry generic PV cable
(model: PV1-F)
2.5-4
(12-10AWG)
2.5(12AWG)
The steps to assemble the PV connectors are listed as follows:
a) Strip the insulation of the PV wire by 7 mm, disassemble the cap nut of the connetctor,
thread one PV wire through the cap nut of the connector (see Pic 5.3). Repeat this operation
with all the PV wires, paying special attention to the polarity of the connector.
b) Crimping metal terminals with crimping pliers , as shown in Pic 5.4.
c) Insert the contact pin to the top part of the connector and completely tighten the cap nut to
the top part of the connector, as shown in Pic 5.5.
Pic 5.3 Disassemble the connector cap nut
Pic 5.4 Crimp the contact pin to the wire
Chart 3-6
7mm
7mm
Hydraulic pliers
Bekijk gratis de handleiding van Deye SUN-70K-SG02HP3-EU-EM6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Deye |
| Model | SUN-70K-SG02HP3-EU-EM6 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8311 MB |
