Deye BOS-G Pro handleiding
Handleiding
Je bekijkt pagina 38 van 59
35
4. After the battery module is placed in the control box, take out a 250 mm communication
cable to connect the communication port of the battery module and the high-voltage
control box, and 11x160mm communication cables to connect the battery module
communication port (IN-OUT) from top to bottom.
The OUT communication port of the last battery module does not need to be connected to
communication cable. Instead, this port is sealed with a 120ohm terminal resistor.
5. Take out a 140 mm positive power cord and connect the positive pole of the battery module
at the top to the positive pole of the high-voltage control box. Take out 11x200mm battery
module power cords and connect the power ports (B- to B+) in a top to bottom order to
form a series circuit. For aesthetics, connect the negative power pole of the first battery
module to the negative power pole of the high-voltage control box from the bottom of the
battery module to the back of the rack. On the back of the rack, a plane-head-shaped tie is
used to secure the cable harness.
6. Take out the external positive power cord EPCable2.0 and external negative power cord
ENCable2.0, and plug them into PCS interfaces, respectively.
7. Take out the ground wire A and connect one end of it to the M4 rivet nut of the high-voltage
control box panel, and the other end to any M6 screw hole of the cross beam above the rack.
Take out the ground wire B (user need to prepare in advance) and connect one end of it to
any M6 screw hole of the cross beam under the rack, and the other end to the customer's
grounding point. (The length of the ground wire B is determined based on the customer's
condition.)
4.11 Battery cluster connected to inverter
For the Australian Market, an over-current Protection and isolation device that isolates both
positive and negative conductors simultaneously is required between the battery system and
inverter
Battery cluster connected to inverter
Notice: The length of the communication line between the inverter and the battery should not
exceed 30m.
Bekijk gratis de handleiding van Deye BOS-G Pro, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Deye |
| Model | BOS-G Pro |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13342 MB |
