DeWalt DXPGH2SB21 handleiding
Handleiding
Je bekijkt pagina 44 van 50
DXPGH2SB21 / DXPGB2WD21
44
AUTOMATIC DARKENING FILTER (ADF)
Troubleshooting
1. AUTO DARKENING FILTER DOES NOT DARKEN OR FLICKER
• Check the lens cover for dirt and spatter that may be blocking the arc sensors.
• The sensors may be dirty, wipe them clean with a soft lint-free cloth.
• Check the sensitivity setting recommendations and increase the sensitivity if possible.
• Increasing lens delay 0.1-0.9 second may also reduce flickering.
• Check batteries and verify that they are in good condition and installed correctly.
• Battery terminals and the contact surface of the filter are dirty or oxidized (clean both).
• Shade adjustment knob is on “GRIND” position, set helmet on “WELD” and/or proper
shade from “5-8 / 9-14”.
2. THE LENS STAYS DARK AFTER THE WELD ARC IS EXTINGUISHED, OR THE AUTO-LENS
STAYS DARK WHEN NO ARC IS PRESENT.
• Fine-tune the sensitivity setting in small increments. In extreme light conditions, it may be
necessary to reduce the surrounding light levels.
3. SLOW SWITCHING
• The operating temperature is too low. Don’t use at temperatures of below -5˚C (+23˚F).
4. POOR VISION
• The cover lens and the filter cartridge are dirty or damaged, clean the dirty components
and replace the damaged ones.
• Ensure ambient light is not too low.
• Ensure the shade number is correct and adjust accordingly.
WARNING: If the described malfunctions cannot be solved, stop using the helmet
immediately and contact your nearest Service Agent at
www.2helpu.com/world/
Bekijk gratis de handleiding van DeWalt DXPGH2SB21, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | DeWalt |
| Model | DXPGH2SB21 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6733 MB |
