DeWalt DXPGH2SB21 handleiding
Handleiding
Je bekijkt pagina 28 van 50
DXPGH2SB21 / DXPGB2WD21
28
SERVICING
Remove clips from both sides of the face shield
frame as shown. (Figure 37)
Remove face shield from the frame. (Figure 38)
Carefully reassemble, fitting the new face shield in reverse order. Tools are not required for
reassembly.
Helmet Shells
Helmet shells must only be replaced by a Service Agent under DEWALT. If the helmet shell has
sustained an impact, it should be replaced immediately, even if the damage is not visible.
Once the helmet shell has been impacted, the materials may be weakened and may no longer
provide its intended impact and penetration resistance.
When subjected to an impact, return the complete respirator to a Service Centre for
assessment. The respirator should be stored out of direct sunlight and the helmet shell should
be replaced every 5 years.
Figure
37
Figure 38
Bekijk gratis de handleiding van DeWalt DXPGH2SB21, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | DeWalt |
| Model | DXPGH2SB21 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6733 MB |
