DeWalt DXF1840 handleiding
Handleiding
Je bekijkt pagina 7 van 23
•
handle screws and tighten. Do not over-tighten.
•
Align handles
2
dna
3
4
1
Align with (packed separately), press into
until protrudes out open hole in .
8
8 8
10
6 6
7
•
Align the , assembled bracket and with the
screw hole on the drum as the order shown in the
image above. Tighten them clockwise. Note: parts
may need to be exed slightly to allow for proper
alignment.
• Repeat above process for opposite side of fan.
ENGLISH
5
5. Fan Connection: Plug fan directly into
NOTE: To prevent overloading a circuit, do
not plug the fan into a circuit that is servicing
other electrical loads.
120 volt A.C., 60Hz wall outlet. Be sure plug
cause overheating and damage to the plug
or fan.
6. Turning Fan On: Place fan on stable
level surface. Plug fan into properly grounded
outlet. To start the fan, turn the switch from
the OFF position to the desired fan speed.
7. Turning Fan Off: To turn the fan off, turn
the switch from the current fan speed setting
to the off position. Remove plug from outlet.
8. Adjusting Fan Tilt: Loosen the
adjustment knob until the drum rotates freely
on the frame. Adjust the fan to desired tilt
angle and re-tighten the knob. Do not
overtighten adjustment knob.
CARE and MAINTENANCE
Cleaning:
Before cleaning the fan be sure
to disconnect power cord from the plug.
Clean the grille surface with a clean damp cloth.
Do not use harsh chemical or abrasive cleaners.
Maintenance: The Internal motor bearings
Repair:
DO NOT OPERATE THE FAN
WITHOUT THE GRILLE IN PLACE. DO NOT
USE THE FAN IF IT HAS MALFUNCTIONED
OR BECOME DAMAGED IN ANY WAY.
Storage: Keep original carton for storage
of the fan.
Coil and tie the power cord to avoid damage
during storage.
Free warning label replacement: If
warning labels become illegible or are missing,
please call 1-888-899-0146 for
free replacement.
are permanently lubricated at the factory and
do not require any additional lubrication.
WARNING:
DO NOT IMMERSE THE FAN
OR ANY WIRES IN WATER. Replace front grille
before fan use and allow fan to dry completely
before use. Periodic grille cleaning with a
vacuum will prevent dust build up. The motor
is sealed and does not require any interior
maintenance, cleaning or lubrication.
WARNING:
WARNING:
OPTIONAL ACCESSORIES
Since accessories, other than
WARNING:
those offered by D
E
WALT, have not been
tested with this product, use of such
accessories with this appliance could be
hazardous. To reduce the risk of injury, only
D
E
WALT recommended accessories should be
used with this product.
3. Fan Operation: Always operate the fan
with the cradle in its upright position. The fan
itself can be titled into various positions
depending on applications, including straight
upward.
4. Fan Location: Place the fan in an area in
the room that will provide the most effective
air circulation.
9
Bekijk gratis de handleiding van DeWalt DXF1840, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | DeWalt |
| Model | DXF1840 |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 3851 MB |
