Handleiding
Je bekijkt pagina 76 van 149
Figure 33. Removing the system board
Steps
1. Remove the screw (M2x2.5) that secure the WLAN bracket to the palm-rest assembly.
2. Lift the WLAN bracket off the palm-rest assembly.
3. Disconnect the WLAN cables from the WLAN card.
4. Remove the two screws (M2x2.5) that secure the display-cable bracket to the palm-rest assembly.
5. Lift the display-cable bracket off the palm-rest assembly.
6. Lift the black flap near the antenna cables and uncover the sensor board-cable.
7. Disconnect the camera cable and display cable from the system board.
8. Disconnect the sensor-board cable from the connector on the system board.
9. Remove the display cable from the routing guides on the system board.
10. Disconnect the display cable from the display cable connector (LCD1) on the system board.
11. Open the latch and disconnect the touchpad cable from the touchpad cable connector (TPAD1) on the system board.
12. Open the latch and disconnect the USH cable from the USH module.
13. Remove the four screws (M2x3) that secures the system board to the palm-rest assembly.
NOTE: Loosen the captive screws in the reverse sequential order mentioned on the heat sink [ 3 > 2 > 1].
14. Remove the three screws (M2x3) that secure the system board to the I/O board.
76
Removing and installing Field Replaceable Units (FRUs)
Bekijk gratis de handleiding van Dell Pro 13 Plus, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dell |
| Model | Pro 13 Plus |
| Categorie | Laptop |
| Taal | Nederlands |
| Grootte | 55186 MB |
