Definitive Technology Dymension Outdoor LS-6.1 handleiding

Speaker

Definitive Technology

33 pagina's

PDF beschikbaar

Handleiding

English

7. Installing the Subwoofer

The subwoofer can be connected anywhere in the daisy chain. However, positioning the subwoofer in the middle of the

daisy chain with equal spacing between the speakers will typically provide a more balanced frequency response across

the listening area.

1. As with the satellite speaker installation, create a loop approximately 10" in length, pulling the wire from the spool

side. Leave 14-16" of excess wire so that the wire doesn’t kink or pull taut when covering the wire with dirt in the

trench. Use a wire tie to hold the wire loop in place and provide strain relief (see Figure 8).

2. Twist to combine the positive wires for the right channel together, followed by the negative wires for the right

channel. Repeat for the left channel wires. See the tables below for subwoofer connection reference. Do not

connect the subwoofer left and right channels together in parallel.

IMPORTANT: The positive and negative wires must be connected correctly for both subwoofer

channels (left and right). If either channel is connected in reverse, the subwoofer will not pass

audio due to phase cancellation.

8. Finalizing the Installation

1. With all the satellites and subwoofer properly connected, ensure the amplifier/receiver is powered off. Connect the

left/right speaker wires to the matching positive (+) and negative (-) terminals on the amplifier/receiver (see the amp

wiring diagram in Figure 3).

2. Adjust the vertical angle of the LS-400 speakers: Hold the speaker’s head while loosening the adjustment knob

with the other hand. Adjust the vertical angle so that the speaker’s head points toward the listening area and then

tighten the adjustment knob. Repeat for each LS-400 in the system.

3. Power on the sound source and amplifier/receiver, then test the system with music.

4. Once it is confirmed that all the satellites and subwoofer are operating correctly, fill in the hole around the

subwoofer and wire trench to complete the installation.

For support, FAQs or more information about these products,

please visit www.definitivetechnology.com or scan the QR code.

Bury the Subwoofer

Dig a hole with a 16" diameter and a depth of 16". Place the subwoofer in the hole and ensure

there is about 6" of exposed subwoofer enclosure from the ground to the bottom edge of the

subwoofer canopy (see Figure 9). It is recommended to test the system as described in section

8 “Finalizing the Installation” below before filling in the hole.

Figure 9

6”

16”

Polarity Burial Wire Subwoofer Coil 2

+ White White

- Green Green

Left Amp Channel

Polarity Burial Wire Subwoofer Coil 1

+ Red Red

- Black Black

Right Amp Channel

Figure 8

FROM AMPLIFIER TO NEXT SPEAKER

RIGHT LEFT

Bekijk gratis de handleiding van Definitive Technology Dymension Outdoor LS-6.1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.