Deaf Bonce Apocalypse Atom 900.2 PRO handleiding

Niet gecategoriseerd

Deaf Bonce

24 pagina's

PDF beschikbaar

Handleiding

5. WIRING DIAGRAMS

Connect the speaker cables from the positive and negative terminals of the speakers to the respective outputs of the

ampliﬁer terminal marked with CH1 / CH2 SPEAKERS OUTPUTS, as shown at the diagram. To connect the power wire supply

it is necessary to use special power cables. The fuse is placed in the holder and ﬁxed in the cable cut. One end of the cable is

connected to the positive terminal of the battery, the second one – to the ampliﬁer terminals marked with +12V. Be sure to

use a fuse with the parameters suﬃcient for use in the system. The length and diameter of the grounding cable must conform

to the length and diameter of the cable +12V. Connect one end to the negative terminal of the battery and the other end of

the grounding cable to the terminals marked with GND. Connect the head unit (HU) to low-level inputs of the ampliﬁer using

RCA cable.

Standard wiring diagram of two-channel ampliﬁer to two speakers.

Step 1. Connect the speaker cable from (+) terminal of the ampliﬁer to (+) terminal of the speaker.

Step 2. Connect the speaker cable from (-) terminal of the ampliﬁer to (-) terminal of the speaker.

Step 3. Repeat the installation sequence Step 1 and Step 2 for each speaker.

1-8 Ohm 1-8 Ohm

Caution!!! The minimum permissible connection load impedance at every single channel is 1 Ohm.

For models Atom 500.2 Pro, Atom 700.2 Pro, Atom 900.2 Pro the operating voltage is 9-15V.

Bekijk gratis de handleiding van Deaf Bonce Apocalypse Atom 900.2 PRO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.