De Dietrich DPV4605HB handleiding
Handleiding
Je bekijkt pagina 16 van 20
• 1USE
1 The hot plate must be selected.
2 Select power 9 with /
(4/5) and then reduce it to the
selected level of power (for
example 6). When the automatic
cook function starts "A" indication
flashes with desired power level
on the display.
SWITCHING THE PREHEAT
FUNCTION OFF
After at least 10 s
econds have elapsed
since the beginning of the automatic
cook start function:
1
The hot plate must be selected.
2 Pr
ess touch k
ey
(5) till the
indicator reaches level 9 and the
automatic cook start function will be
deactivated.
Timer Function
This function makes it easier to cook,
as you do not need to be present
throughout the process: the timed hot
plate(s) will switch off automatically
after the set time has lapsed. There is a
separate timer for each hot plate, which
allows all of the hot plates to be timed
simultaneously.
With these models you can use the
clock as a timer for the hotplates for
times ranging from 1 to 99 minutes. All
the cooking areas can be programmed
individually and in a simultaneous
manner.
TIMING ONE COOKING ZONE
1 The cooking zone to be timed must
be selected.
2 Select a power level for the cooking
zone from 1 to 9 using the touch keys
or / (5/4).
3 Press the clock touch key (8).
Timer indicator (9) will display 00.
Depending on the model, the timed
cooking surface indicator (10) will
flash.
On the power indicator (3), will flash
during the time set.
4 Immediately afterwards, enter a
cooking time between 1 and 99
minutes, by using the touch keys or
(4/5).
When the power indicator (3) stops
flashing, it will start to count down the
time automatically. The respective
timed hotplate display (9) will continue
flashing.
Or, when the countdown starts, the
relevant power level and will flash
alternately on the power indicator (3)
of the relevant heater area.
When the clock reaches 01, it will
switch from counting down minutes
to seconds.
Once the selected cooking time has
elapsed, the heating zone being timed
is turned off and the clock emits a series
of beeps for several seconds. The
timer indicator will display a flashing
00 beside the hotplate that has been
disconnected.
If you wish to time another hotplate at
the same time, repeat steps 3 and 4.
If the heating zone turned off is hot, its
indicator displays an H or otherwise an
0. To turn off the audible signal touch
any sensor.
CHANGING THE PROGRAMMED
TIME
To change the progrmmed time, you
must press the touch key of the timed
hotplate (2) to select it and then the
clock (8). You may then read and
change the time.
DISCONNECTION OF THE TIMER
If you want to stop the timer before the
programmed time is up:
1 First select the hotplate and then
press clock touch key (8).
2 Use the touch key (4) to recede
the time to 00. The clock is cancelled.
Alternative method :
After zone selection if the timer touch
key is pressed
for two seconds, the
related timer will be cancelled.
Safety switch off function
If due to an error one or several hot
plates do not switch off, the appliance
will be automatically disconnected after
a set amount of time (see table 2).
1
2
3
4
5
6
7
8
9
10
Table 2
5
5
4
3
2
2
2
1
Selected
power
level
MAXIMUM OPERATION
TIME
(in hours)
When the “safety switch off” function
has been triggered, a 0 is displayed if
the glass surface temperature is not
dangerous for the user or an H if there
is a burn risk.
To reconnect the appliance, switch it
off by pressing the on/off key (1) and
then switch it on again.
Keep the control panel of the
heating areas clean and dry at all times.
In case of operating problems
or incidents not mentioned in this
manual, disconnect the appliance
and contact the De Dietrich
technical service.
Recommendation for the
good use of vitroceramic
hobs
* Use pots or pans with thick,
completely flat bottoms.
* Pans with a smaller diameter than
the shown heating area are not
recommended.
* Do not slide pots and pans over the
glass as they may scratch it.
* Although the glass can withstand
knocks from large pots and pans
without sharp edges, try not to
knock it.
* To prevent damage to the ceramic
PREHEAT FUNCTION
16
Bekijk gratis de handleiding van De Dietrich DPV4605HB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | De Dietrich |
| Model | DPV4605HB |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3317 MB |
