Datapath Hx4 handleiding
Handleiding
Je bekijkt pagina 25 van 33
Operation
7.4.1 Network Settings
The Network Settings become active once you have successfully connected to an Hx4 either by USB or Ethernet.
The Hx4 allows you to switch between Dynamic (DHCP) and Static IP’s. Out of the box, the Hx4 is congured to accept DHCP.
When DHCP is selected the network will assign the Hx4 with an IP address, this IP address can change depending on how the
network allocates IP addresses.
If the Hx4 is assigned a Static IP address it will keep that address until it is changed by the user.
The IP Address, Subnet Mask and Gateway elds are not available to edit if DHCP is selected and the display settings are
assigned via a DHCP server.
In Static mode the IP Address, Subnet Mask and Gateway can be manually congured.
Ethernet Port
Connect the Hx4 to a network using the LAN connector then open Wall Designer and create your display layout as
described in Paragraph 7.3.
At the point where you associate the virtual device with a physical device the list will display all Hx4’s currently connected to the
network either directly or daisy chained.
Click on the virtual device to display its properties, the Device Properties can be changed in the same way as if connecting via
USB. Once any changes have been made click on Apply Settings to save.
7.4 Conguring the Hx4 via a Network
The Hx4 has a single ethernet port to allow users to add the device to their network.
Operation
25
Bekijk gratis de handleiding van Datapath Hx4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Datapath |
| Model | Hx4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5125 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Gewicht | 1860 g |
| Breedte | 316 mm |
| Diepte | 172 mm |
| Hoogte | 42 mm |
