Danfoss DST X510 handleiding
Handleiding
Je bekijkt pagina 5 van 42
© Danfoss | DCS (im) | 2019.04
Operation guide | DST X730 Top level inclination sensor
AQ304230922416en-000101 | IC.PS.P21.L1.02 | 5
2.2
6 wires output 18 AWG 1.65 mm OD
CONNECTIONS
White: +Vs (+10 - +36 Vdc)
Yellow: GROUND
Grey: CAN-H
Blue: CAN-L
Pink: NC
Green: NC
Brown: NC
Cables output IEC 60332
Cable 7 pole 0.5 mm²
OD 6.4 mm
NOTE:
Please make sure that the CANbus is terminated.
The impedance measured between CAN-H and
CAN-L must be 60 ohm that means the cable
must be connected to a 120 ohm resistor on each
ends of the bus line. Internally the tranducer is
not terminated with the resistor of 120 ohm.
Do not confuse the signal lines of the CAN bus,
otherwise communication with the transducer is
impossible.
Bekijk gratis de handleiding van Danfoss DST X510, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Danfoss |
| Model | DST X510 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5654 MB |
