Handleiding
Je bekijkt pagina 13 van 52
Electrical Connection and Safety
• Before connecting the appliance to the pow-
er supply, the voltage rating of the appliance
(stamped on the appliance identification plate)
must be checked for correspondence to the
available mains supply voltage, and the mains
electric wiring should be capable of handling
the appliance’s power rating (also indicated on
the identification plate).
• Proper Installation - Be sure your appliance is
properly installed and grounded by a qualified
technician. In the United States, install in accor-
dance with the National Fuel Gas Code ANSI
Z223.1/NPFA No.54, latest edition and Nation-
al Electrical Code NFPA No.70 latest edition,
and local electrical code requirements.
In Canada, install in accordance with CAN/
CGA B149.1 and CAN/CGA B149.2 and CSA
Standard C22.1, Canadian Electrical code, Part
1latest editions and local electrical code require-
ments.
• During installation, please ensure that isolated
cables are used. An incorrect connection could
damage your appliance. If the mains cable is
damaged and needs to be replaced this should
be done by a qualified person.
• Do not use adapters, multiple sockets and/or
extension leads.
• The supply cord should be kept away from hot
parts of the appliance and must not be bent or
compressed. Otherwise the cord may be dam-
aged, causing a short circuit.
INSTALLATION INSTRUCTIONS
13
3. To convert it from NG to LP, change direction
of the adjustment rod. When the letter “LP” on
the adjustment rod faces upward, the regulator
outlet pressure is set to LP.
4. Replace the cap back on the regulator.
Changing injectors
Hob burners
• Cut off the main gas supply and unplug the ap-
pliance from the mains electrical supply.
• Remove the burner caps and the adapters.
• Use a 9/32 “ (7 mm) spanner to unscrew the
injectors.
• Replace the injector with the ones from the gas
conversion kit, with the correct diameters for the
type of gas that is going to be used, according
to the gas injector table.
WARNING
The electrical connection of this appliance should
be carried out by an authorised service person or
qualified electrician, according to the instructions
in this guide and in compliance with the current
local regulations.
THE APPLIANCE MUST BE EARTHED.
Bekijk gratis de handleiding van Danby DR24V1WH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Danby |
| Model | DR24V1WH |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 6271 MB |