Handleiding
Je bekijkt pagina 36 van 49
Page 36
Electrical Connections
1. All wiring must comply with local and national electrical codes, regulations and must be installed
by a licensed electrician.
2. All electrical connections must be made according to the Electrical Connection Diagram located
on the panels of the indoor and outdoor units.
3. If there is a serious safety issue with the power supply, stop work immediately. Explain your
reasoning to the client, and refuse to install the unit until the safety issue is properly resolved.
4. Power voltage should be within 90-110% of rated voltage. Insucient power suply can cause
malfunction, electrical shock, or fire.
5. If connecting power to fixed wiring, a surgeprotector and main power switch should be installed.
6. If connecting power to fixed wiring, a switch or circuit breaker that disconnects all poles and has
a contact separation of at least 1/8in (3mm) must be incorporated in the fixed wiring. The quali-
fied technician must use an approved circuit breaker or switch.
7. Only connect the unit to an individual branch circuit outlet. Do not connect another appliance to
that outlet.
8. Make sure to properly ground the air conditioner.
9. Every wire must be firmly connected. Loose wiring can cause the terminal to overheat, resulting
in product malfunction and possible fire.
10. Do not let wires touch or rest against refrigerant tubing, the compressor, or any moving parts
within the unit.
11. If the unit has an auxiliary electric heater, it must be installed at least 1 meter (40in) away from
any combustible materials.
12. To avoid getting an electric shock, never touch the electrical components soon after the power
supply has been turned o. After turning o the power, always wait 10 minutes or more before
you touch the electrical components.
13. Make sure that you do not cross your electrical wiring with your signal wiring. This may cause
distortion and interference.
14. The unit must be connected to the main outlet Normally, the power supply must have an imped-
ance of 32 ohms.
15. No other equipment should be connected to the same power circuit.
16. Connect the outdoor wires before connecting the indoor wires.
BEFORE PERFORMING ANY ELECTRICAL WORK,
READ THESE REGULATIONS
!
Bekijk gratis de handleiding van Daizuki DX1C18426-21, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Daizuki |
| Model | DX1C18426-21 |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 6253 MB |
