Daikin LMCEY handleiding
Handleiding
Je bekijkt pagina 10 van 230
4 User interface
Operation manual
10
LMCEY1A/W + LMCEY2A/W
Daikin LMC
4P753996-1 – 2024.06
3 s
Result: The display shows three dashes in sequence.
4.2.2 To start up
1 Unlock the user interface. See "4.2.1 To unlock the user
interface"[49].
2 Turn the unit on by pushing the on-off/down arrow button on the
user interface.
Result: The display switches on. It briefly shows the firmware
version.
Result: The unit starts up.
INFORMATION
The compressor starts up after a pre-set delay
(parameter). This function is useful to protect the
compressor and the relay from power cycling in the event
of repeating power outages. Defrosting (if required) also
starts after this delay. The whole process may take a few
minutes. Then the compressor will restart in cooling mode.
INFORMATION
In the off status of the unit, the maximum interval between
consecutive defrosts is always updated, in order to
maintain the cyclical nature of this interval. If a defrost
interval expires while the unit is off, the event is recorded.
When the unit is switched on again, a defrost request is
then generated.
4.2.3
To set the temperature
1 Unlock the user interface. See "4.2.1 To unlock the user
interface"[49].
2 Press the Setpoint/Up arrow button:
.
3 Use the UP and DOWN buttons to change the temperature
setpoint.
Result: The setpoint has changed.
4.2.4 To shut down
1 Unlock the user interface. See "4.2.1 To unlock the user
interface"[49].
2 Turn the unit off by pushing the on-off/down arrow button on the
user interface.
Result: The compressor protection times are observed.
Result: Defrosting is forcibly terminated and will not resume
when switching on.
4.2.5 To navigate between screens
4.2.6
To change the status of an actuator
INFORMATION
If no button is pressed, the terminal will return to the
standard display after 7seconds.
1 Unlock the user interface. See "4.2.1 To unlock the user
interface"[49].
2 Press the PROGRAM button to enter “dir” mode.
Result: The display shows “dir”. The buttons that are on steady
indicate that the corresponding actuator/function is active. The
buttons that are flashing indicate that the actuator/function is
not active.
3 Press a button (e.g. the continuous cycle button).
Result: The status changes (e.g. from active to not active).
4.2.7
To change the status of a direct function
INFORMATION
If no button is pressed, after 20 seconds the terminal will
automatically return to the standard display.
1 Unlock the user interface. See "4.2.1 To unlock the user
interface"[49].
2 Press the PROGRAM button to enter “dir” mode.
Bekijk gratis de handleiding van Daikin LMCEY, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Daikin |
| Model | LMCEY |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 38596 MB |
