Handleiding
Je bekijkt pagina 30 van 68
EWWQ090G ÷ EWWQ720L - R410a - Water-cooled scroll chillers
EWLQ090G ÷ EWLQ720L - R410a - Condenser less
EWHQ100G ÷ EWHQ400G - R410a - Heat pump scroll chillers
EWAQ- - R410a - Air-cooled scroll chillers
EWAQ-G - R410a - Air-cooled scroll chillers
EWYQ- - R410a - Air-cooled scroll heat pumps
Air and Water cooled scroll chillers & heat pump
Operation
Manual
Operation Manual
30
EWWQ - EWLQ - EWHQ
EWAQ - EWYQ
Air or Water cooled scroll chiller &
heat pump
D-EOMHW00106-15EN
Cond Sat Temp=
-
-
Condensing saturated temperature
Suction Temp=
-
-
Suction Temperature
Suction SH=
-
-
Suction Superheat
Evap Approach=
-
-
Evaporator Approach
Cond Approach=
-
-
Condenser Approach
EXV Position=
-
-
Expansion valve position
VFD Speed
0%
0-100%
Fan Speed (A/C only)
4.3.1 Settings
This page resumes the status of the circuit.
Setpoint/Sub-Menu
Default
Range
Description
Compressors
Link to the compressor page
Circ X Cond Ctrl
Link to the circuit condensing control page (W/C only)
Fan Control
Link to the circuit fan control page (A/C only)
EXV
Link to the EXV page
Defrost
Link to the defrost page (A/C only)
4.3.1.1 Compressors
This page resumes all the relevant information about compressors of the related circuit.
Note the following compressors enumeration:
1. Compressor 1 and compressor 3 belong to the Circuit #1
2. Compressor 2 and compressor 4 belong to the Circuit #2
Setpoint/Sub-Menu
Default
Range
Description
Comp Enable
Link to Compressor Enable page
Compressor 1
State
Off
Off, On
Compressor State
Start=
Date and time of the last start
Stop=
Date and time of the last stop
Run Hours=
0h
Running hours of compressor
No. Of Starts=
0
Number of compressor starts
Compressor 3
State
Off
Off, On
Compressor State
Start=
Date and time of the last start
Stop=
Date and time of the last stop
Run Hours=
0h
Running hours of compressor
No. Of Starts=
0
Number of compressor starts
The compressors enable page allows to enable or disable each compressor of the unit.
Setpoint/Sub-Menu
Default
Range
Description
Comp 1
Auto
Off, Auto
Enabling of the compressor
Comp 2
Auto
Off, Auto
Enabling of the compressor (if available)
Comp 3
Auto
Off, Auto
Enabling of the compressor
Comp 4
Auto
Off, Auto
Enabling of the compressor (if available)
If a compressor is switched to off while it is in running, it does not shutdown immediately, but the
controller waits normal shutdown for thermoregulation or unit off and after the compressor disabled
will not started until it is enabled again.
4.3.1.2 Circ 1 Cond Ctrl
This page resumes all parameters for the condensing circuit control. For more details about this
parameters and the circuit condensing control logic refer to section 5.6.2.
Setpoint/Sub-Menu
Default
Range
Description
Cnd Sat Tmp SP=
35.0°C
30.0…50°C
Condensing saturated temperature setpoint
Cnd Sat Tmp=
-
-
Actual condensing saturated temperature
Bekijk gratis de handleiding van Daikin EWAQ-G-SS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Daikin |
| Model | EWAQ-G-SS |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 11467 MB |
