D-Link DPS-PWR740AC handleiding
Handleiding
Je bekijkt pagina 42 van 69
DMS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
42
3. Then we entered the VLAN Configuration Mode of the default VLAN, which is VLAN 1, by entering the
command, interface vlan 1.
4. Then we changed the IP address of the Switch to 10.50.50.50 and the subnet mask to 255.0.0.0 by entering
the command ip address 10.50.50.50 and 255.0.0.0.
The Switch can now be accessed and configured through Telnet or the Web UI. The Switch’s IP address can also be
automatically obtained by using the DHCP protocol.
Connecting to the MGMT Port
The front panel of the Switch features an Out-Of-Band (OOB) RJ45 MGMT port which can be used to connect to a
computer using a standard Ethernet cable. A web browser or Telnet client can be used to connect to the Switch using
the MGMT port.
Note: By default, the Telnet method requires a password to log in to the CLI. After logging in to the Web UI, go to
Management > Login Method. Create a password for telnet in the Login Password section (refer to the following
chapter: Web-based Switch Configuration for access through a web browser).
To use the MGMT port, connect one end of an Ethernet cable to a computer and the other end to the Switch. The
default IP address of the MGMT port is 192.168.0.1 and the subnet mask is 255.255.255.0. Make sure that the
computer being used for the switch management has a non-conflicting IP address in the 192.168.0.0/24 network.
The following screen should be displayed after a successful connection:
To view the IP settings of the MGMT port, use the following command through the console port.:
Switch#show ip interface mgmt 0
mgmt_ipif 0 is enabled, Link status is up
IP address is 192.168.0.1/24
Gateway is 0.0.0.0
Switch#
The IP settings or enabled status of the MGMT port can be changed through the console port. For example, to change
the IP address of the MGMT port, use the following commands:
Switch#configure terminal
Switch(config)#interface mgmt 0
Switch(config-if)#ip address 192.168.1.1 255.255.255.0
Switch(config-if)#
Connecting using SNMP
The Simple Network Management Protocol (SNMP) is an OSI Layer 7 (Application Layer) protocol designed
specifically for managing and monitoring network devices. SNMP enables network management stations to read and
modify the settings of gateways, routers, switches, and other network devices. Use SNMP to configure system
features for proper operation, monitor performance, and detect potential problems in the Switch, switch group, or
network.
Bekijk gratis de handleiding van D-Link DPS-PWR740AC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | D-Link |
| Model | DPS-PWR740AC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10019 MB |
