D-Link DGS-6600-PWR handleiding
Handleiding
Je bekijkt pagina 353 van 761
DGS-6604 m/ mSW Rls. 1.00.029 neighbor
CLI Reference Guide
322
neighbor
Use the neighbor command to define a neighboring router with which to
exchange routing information. Use the no form to remove an entry.
neighbor IP-ADDRESS
no neighbor IP-ADDRESS
Default Not configured
Command Mode Router configuration
Usage Guideline This command allows point-to-point (non-broadcast) exchange of routing
information. Additional neighbors or peers can be specified using multiple
neighbor commands.
When used in combination with the passive-interface router configuration
command, routing information can be exchanged between a subset of routers
and access servers on a LAN.
Example In the following example, RIP updates are sent to all interfaces except vlan1 on
network 10.0.0.0/8. However, in this case a neighbor router configuration
command is included. This command permits routing updates to be sent to
specific neighbors. One copy of the routing update is generated per neighbor:
Verify the settings by entering the show ip protocols rip command
Syntax Description
IP-ADDRESS IP address of a peer router with which routing information will be exchanged.
Switch# configure terminal
Switch(config)# router rip
Switch(config-router)# network 10.0.0.0/8
Switch(config-router)# passive-interface vlan1
Switch(config-router)# neighbor 10.50.71.50
Bekijk gratis de handleiding van D-Link DGS-6600-PWR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | D-Link |
| Model | DGS-6600-PWR |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 52758 MB |
Caratteristiche Prodotto
| Kleur van het product | Grijs |
| Breedte | - mm |
| Diepte | - mm |
| Hoogte | - mm |
| Geluidsniveau | - dB |
