D-Link DGS-6600-PWR handleiding
Handleiding
Je bekijkt pagina 241 van 761
DGS-6604 m/ mSW Rls. 1.00.029 ip ospf dead-interval
CLI Reference Guide
210
ip ospf dead-interval
Use this command to set the interval during which no hello packets are received
and after which a neighbor is declared dead. The no form of this command will
reset the dead-interval to the default value.
ip ospf dead-interval SECONDS
no ospf dead-interval
Default 40 seconds
Command Mode Interface configuration
Usage Guideline The dead-interval is the amount of time that the router waits to receive an OSPF
hello packet from a neighbor before declaring the neighbor down.
This value is advertised in the router's hello packets. It must be the same for all
routers on a specific network.
Specifying a smaller dead interval in seconds will give faster detection of a
neighbor being down and improve convergence, but it may cause additional
routing instability.
Example The following example shows configuring dead-interval to 10 seconds on VLAN 1
interface.
Verify the settings by entering the show ip ospf interface command.
Syntax Description
SECONDS Specifies the interval in seconds. The range is 1 to 65535.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ip ospf dead-interval 10
Bekijk gratis de handleiding van D-Link DGS-6600-PWR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | D-Link |
| Model | DGS-6600-PWR |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 52758 MB |
Caratteristiche Prodotto
| Kleur van het product | Grijs |
| Breedte | - mm |
| Diepte | - mm |
| Hoogte | - mm |
| Geluidsniveau | - dB |
