CYP SDV-CS8 handleiding
Handleiding
Je bekijkt pagina 18 van 76
13
4) HDMI Audio Routing: Provides drag-and-drop control over the
independent HDMI audio routing of all detected transmitters and
receivers.
Note: Bitstream audio is only supported when the receiver’s HDMI audio
device setting is set to “HDMI Audio (Follow Video in Genlock Mode)”.
HDMI Audio Transmitter: This section provides drag-and-drop
buttons for all transmitters detected by the system as well as a
button target to stop one or all independent HDMI audio streams
from being transmitted.
Source to Single Receiver Routing: To route an HDMI audio source
to a receiver, click and drag the source’s button on the left to the
preferred display on the right side, then release the mouse button.
If the routing was completed successfully, the newly routed source’s
name will appear below the display’s name within the button.
Clicking on any source button will change the colour of itself, and
all currently routed displays.
Note: Receivers may also be drag and dropped onto sources to activate
a new route.
Source to Multiple Receiver Routing: To route an HDMI audio
source to multiple receivers at the same time, click and drag the
source’s button on the left to a Group button or the “All” button on
the right side, then release the mouse button. If the routing was
completed successfully, the source’s name will appear within all
appropriate buttons.
Stop Stream: To stop the independent HDMI audio stream from
a single source, drag the source down to the “Stop” button at the
bottom of the window, then release the mouse button. To stop ALL
Bekijk gratis de handleiding van CYP SDV-CS8, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | SDV-CS8 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6049 MB |
