CYP SDV-CS8 handleiding
Handleiding
Je bekijkt pagina 14 van 76
9
Note: The IP Master Controller has an automatic bandwidth reduction
feature to prevent situations where a source’s streams will exceed
10Gbps, but in the unlikely event a transmitter’s streams still require
more bandwidth than is available, the video output may become
visually unstable. In these situations it is recommended to reduce the
resolution, framerate, or bit depth of the original source.
Source to Single Receiver Routing: To route a source to a receiver,
click and drag the source’s button on the left to the preferred
display on the right side, then release the mouse button. If the
routing was completed successfully, the newly routed source’s
name will appear below the display’s name within the button.
Clicking on any source button will change the colour of itself, and
all currently routed displays.
Note: Receivers may also be drag and dropped onto sources to activate
a new route.
Source to Multiple Receiver Routing: To route a source to multiple
receivers at the same time, click and drag the source’s button on
the left to a pre-dened Video Group or “All” button on the right
side, then release the mouse button. If the routing was completed
successfully, the source’s name will appear within all appropriate
buttons.
All/Native/Multiview Stream Stop: In certain situations it may
become necessary to stop one or all of the video streams coming
from a source. To do this, rst select the type of stream to stop by
clicking on the cycle selection icon (
) at the bottom of the window
until the preferred option (All Stop, Native Stop, Multiview Stop) is
displayed. Next, click and drag the source down to the chosen “Stop”
button. The chosen stream type will be immediately terminated. To
stop a stream type from ALL video streams simultaneously, drag the
“All” button down to the chosen “Stop” button.
“All Stop” stops all stream types from the selected source, “Native
Stop” stops only the full resolution primary video stream, “Multiview
Stop” stops only the secondary video stream used by multiviewer
layouts.
Video Receiver: This section provides drag-and-drop buttons for
all receivers detected by the system as well as a button target to
stop one or all output streams from being displayed.
Bekijk gratis de handleiding van CYP SDV-CS8, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | SDV-CS8 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6049 MB |
