CYP PUV-2608TX handleiding
Handleiding
Je bekijkt pagina 17 van 56
12
- Power Off: Turn off the connected HDMI display device.
- Active Source: Force the connected HDMI display device to
switch to the HDMI input that this unit is connected to.
- Power On + Active Source: Turn on the connected HDMI display
device and force the connected HDMI display device to switch to
the HDMI input that this unit is connected to.
Note: Not all HDMI devices support all CEC commands.
3) RS-232: Enable or disable sending a RS-232 command when the
currently selected Automation Event is activated. Click the “Edit” icon
( ) to configure the various RS-232 port settings including baud rate,
data length, parity and stop bits.
Note: RS-232 commands will be sent across the bypass RS-232 ports on
both the transmitter and receiver.
Delay: Set the length of time, in seconds, that the specified
Automation Event must continue to be true before sending the
defined RS-232 command.
Wait: Set the length of time, in seconds, to wait after this
Automation Event has been activated before ANY other Automation
Event can be detected.
RS-232 Command: Displays the currently defined RS-232 command
text. Click on the “Edit” icon (
) to define the RS-232 command to
send when the specified Automation Event is activated. Click the
“Test” button to send the command immediately.
Bekijk gratis de handleiding van CYP PUV-2608TX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | PUV-2608TX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4000 MB |
