CYP IP-CS9000 handleiding
Handleiding
Je bekijkt pagina 10 van 72
5
5
HDMI OUT Port: Connect to a standard HDMI display to view the
unit’s current status information and access the WebGUI directly
without a PC.
Note: HDMI output is locked to a resolution of 1080p@60Hz.
6
USB Port: Connect a USB mouse and keyboard to control the unit’s
WebGUI displayed on the HDMI output port.
Note: Specialised USB control devices, such as a touch panel, should be
connected before the unit is powered on.
7
LAN 2 Port: Connect directly, or through a network switch, to your
PC/laptop to control the unit via WebGUI/Telnet.
Note: This LAN port cannot support AutoIP devices and should ONLY be
used for external control of the IP Master Controller itself.
8
LAN 1(POE) Port: This port is used to connect to the extension units
to be controlled. Connect to the extension units’ private network
through their dedicated network switch, to enable detection and
control over those units.
Note: If the connected network switch supports the IEEE 802.3af 2003
PoE (Power over Ethernet) standard, this unit can optionally be powered
directly via this Ethernet port.
9
FACTORY RESET Pinhole: Press and hold for 3 seconds to reset the
unit to its factory defaults, including Ethernet settings.
Note: While the reset is in process, the LEDs on the front of the unit will
illuminate red. Once the reset is complete, the unit will return to normal
operation.
10
DC 5V Port: The IP-CS9000 will be powered directly by PoE (IEE
802.3af 2003 PoE standard) but an optional PSU (PSU-5V2.6A-L) is
available to purchase as required.
Bekijk gratis de handleiding van CYP IP-CS9000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | IP-CS9000 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5938 MB |
