CYP IP-9000RX handleiding
Handleiding
Je bekijkt pagina 23 van 60
18
1) IP Setup: This section allows for configuration of the IP acquisition
mode and Ethernet settings of the unit. It also provides an easy way to
find the physical unit when installed with many other similar units.
IP Mode & Settings: The IP mode may be switched between “Auto
IP”, “DHCP” or “Static IP”. When the unit is set to Auto IP mode it
will automatically assign itself an APIPA address from the 169.254.
xxx.xxx range. When the unit is set to DHCP mode it will attempt
to automatically obtain an IP address from a DHCP server. When
the IP mode is set to static IP, you can manually set the IP address,
netmask and gateway address. Click the “Apply” button to save
changes made to the IP Mode or Configuration.
Note: The default network setting for this unit is “Auto IP”.
Find Your Device: Selecting “Show Me” will cause the unit to
immediately begin flashing the LEDs on the front of the unit to
make it easy to find. Selecting “Hide Me” returns the LEDs to their
normal behavior. This setting is useful when troubleshooting an
installation with a large number of units in a rack.
2) Casting Mode: Allows for the selection of the network broadcast
mode supported by the receiver. Click the “Apply” button to save
changes made to the broadcast mode.
Note: Receivers must be set to the same mode as the transmitter in order
to receive video.
Multicast: This mode sends a single video stream that can be
viewed simultaneously by multiple receivers without increasing
bandwidth usage. This mode is ideal for video wall or matrixing
scenarios. Multicast mode requires a network switch with IGMP
snooping enabled.
Unicast: This mode uses a discrete video stream for every
connected receiver and is ideal for simple, point-to-point, streaming
setups. This mode uses considerably more bandwidth than
Multicast Mode when multiple receivers are being used, however it
does not require a network switch that supports IGMP snooping.
3) ID (Channel): To change the broadcast reception channel for the
receiver, type the new channel in the space provided. The receiver
will display the video stream from the transmitter using the selected
broadcast channel. The available channel range is from 0 to 255.
Bekijk gratis de handleiding van CYP IP-9000RX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | IP-9000RX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4713 MB |
