CYP DS-VWC handleiding
Handleiding
Je bekijkt pagina 13 van 48
13
6.3.3 Basic Unit Settings & Configuration
The basic configuration and settings for each connected unit can be
set by selecting the unit to configure from the “Unit” section and then
clicking on the “Setting” button in the upper-left “Common” section of the
window. The operational mode of the unit (Rotate Mode or Scaler Mode)
may be set here, as well as the Ethernet, I/O, and mode-specific image
features. To exit the setting configuration tabs and return to the layout
mode, click on the “Layout” button in the upper-left “Common” section of
the window.
Note: Some configuration options are not available in both modes.
The “General” tab provides control over the network configuration, and
provides a way to initiate a firmware update or perform a factory reset.
This tab provides the same options in both operational modes.
1) System Setup: Displays the current firmware version and provides
options to update the firmware or perform a factory reset on the unit.
■
Update FW Button: Provides a way to update the unit’s firmware.
Insert a USB thumb drive, with a valid firmware file (*.bin format)
in the root directory, into the unit’s USB service port then click the
“Update FW” button. After the update is complete the unit will
automatically reboot.
■
Factory Reset Button: Selecting this will reset the unit’s settings
back to their factory defaults.
2) Network Configuration: The IP Address, Netmask and Gateway
Bekijk gratis de handleiding van CYP DS-VWC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | DS-VWC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3951 MB |
