Curtis Electronic Code Switch handleiding

Niet gecategoriseerd

Curtis

73 pagina's

PDF beschikbaar

Handleiding

6 — PROGRAMMABLE PARAMETERS

pg. 29

Return to TOC Curtis Electronic Code Switch Module (ECS) – June 2022

PASS THROUGH MODE MENU

e Pass rough Mode menu is visible if the ECS is operating in pass-through mode. Pass-through

mode allows another CAN device to receive keypad entries and RFID tag swipes and to control the

buzzer and LEDs. Pass-through mode has the following characteristics:

• Users cannot log on.

• e ECS remains in the idle state.

• e Input PushButton Value parameter stores the keys that were entered before the button

was pressed. e parameter is reset to 0 if the Clear PushButton Value parameter is set to On

or an RFID tag is swiped.

• e RFID 0/1/2 parameters store the UIDs of swiped tags. ere are two ways to reset these

parameters to 0:

– If the Receive RFID Input Only parameter is set to O, the user can press one or more

numeric keys, then press the button.

– If the RFID Swipes Logo Enable parameter is set to On, the user can swipe the same RFID

tag again.

To enable pass-through mode, set the Pass rough Switch parameter to 1.

e following table describes the Pass rough Mode parameters.

PASS THROUGH MODE MENU

PARAMETER

CAN INDEX

VALUES

RAW VALUES

DATA SIZE

READ/WRITE

ACCESS LEVEL

DEFAULT VALUE DESCRIPTION

Input PushButton Value

0x5902:00

0–999999999

32-bit

OEM Dealer

N/A

Indicates the keys that were pressed before the

button was pressed.

9 is prepended to the key numbers. For example, if the

3579 keys were pressed, the value would be 93579.

Note: If more than eight keys have been pressed, the

buzzer sounds the Error sound to indicate that the

maximum value was exceeded.

Clear PushButton Value

0x5902:01

Off/On

0–1

8-bit

OEM Dealer

Sets the Input PushButton Value parameter to 0

when On is specied.

RFID 0

0x5901:00

0–4294967295

32-bit

OEM Dealer

N/A

Indicates the rst four bytes of the RFID tag’s UID.

RFID 1

0x5901:01

0–4294967295

32-bit

OEM Dealer

N/A

Indicates the second set of bytes of the RFID tag's

UID. The value depends upon the tag’s cascade level:

• Cascade level 2: Three bytes

• Cascade level 3: Four bytes

RFID 2

0x5901:02

0–4294967295

32-bit

OEM Dealer

N/A

For cascade level 3 tags, indicates the last two bytes

of the tag’s UID.

Clear RFID Input Value

0x5902:02

Off/On

0–1

8-bit

OEM Dealer

Off

When set to On, clears the RFID 0, RFID 1, and RFID

2 parameters.

Bekijk gratis de handleiding van Curtis Electronic Code Switch, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.