Curtis 1352 handleiding
Handleiding
Je bekijkt pagina 13 van 40
2 — INSTALLATION AND WIRING
pg. 9
Return to TOC Curtis 1352 eXm Manual, June 2021
INPUT/OUTPUT SIGNAL SPECIFICATIONS
e input/output signals wired to the 14-pin connector can be grouped by type as follows; their
electrical characteristics are discussed below.
• digital inputs
• digital outputs
• analog inputs with virtual digital input
• power
• communication lines.
Digital inputs
e six digital I/O lines can be used as digital (on/o) inputs. Normal “on” connection is direct to
B+; “o” is direct to B–. Input will pull low (o) if no connection is made.
DIGITAL INPUT SPECIFICATIONS
SIGNAL NAME PIN
LOGIC
THRESHOLDS*
INPUT
IMPEDANCE*
PROTECTED
VOLTAGE RANGE
ESD
TOLERANCE
Input/Output 1 11 All models:
Low = 2.8 V
High = 6.3 V
12–36V models:
about 10 kΩ
36–80V models:
about 47 kΩ
12–36V models:
–0.5 to 50 V
36–80V models:
–0.5 to 105 V
All models:
±8 kV (air
discharge)
Input/Output 2 12
Input/Output 3 13
Input/Output 4 14
Input/Output 5 9
Input/Output 6 10
*Tolerance ±5%.
51
1410
6 9
Because these six lines can also be used as driver outputs, it is important to ensure that Output Driver
Mode is set appropriately for each line. For each pin that will be used as a digital input, Output Driver
Mode must be set to Input Only (see page 26). Otherwise, a direct short from the battery through the
internal driver FET will occur when the input is switched high and the FET is turned on.
Bekijk gratis de handleiding van Curtis 1352, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Curtis |
| Model | 1352 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5176 MB |
