Curtis 1253 handleiding
Handleiding
Je bekijkt pagina 10 van 49
4
Curtis 1253 Manual, Rev. F
2 — INSTALLATION & WIRING: Controller
Working on electrical systems is potentially dangerous. You should
protect yourself against uncontrolled operation, high current arcs, and
outgassing from lead acid batteries:
UNCONTROLLED OPERATION — Some conditions could cause the hydraulic
pump system to run out of control. Disconnect the motor or make sure
the pump system has enough room to operate before attempting any
work on the motor control circuitry. Note: If the wrong throttle input
signal type is selected with the programming device, the pump system
may suddenly begin to operate.
HIGH CURRENT ARCS — Batteries can supply very high power, and arcs can
occur if they are short circuited. Always open the battery circuit before
working on the motor control circuit. Wear safety glasses, and use
properly insulated tools to prevent shorts.
LEAD ACID BATTERIES — Charging or discharging generates hydrogen gas,
which can build up in and around the batteries. Follow the battery man-
ufacturer’s safety recommendations. Wear safety glasses.
provided. Although not usually necessary, a thermal joint compound can be
used to improve heat conduction from the controller heatsink to the mounting
surface.
You will need to take steps during the design and development of your
end product to ensure that its EMC performance complies with applicable
regulations; suggestions are presented in Appendix A.
☞
CAUTION
Bekijk gratis de handleiding van Curtis 1253, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Curtis |
| Model | 1253 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6360 MB |
