Curtis 1229 handleiding
Handleiding
Je bekijkt pagina 13 van 143
2 — INSTALLATION AND WIRING
pg. 7
Return to TOC 1229 Manual - OS 1.8 RevA - May 2021
Motor wiring (M1, M2)
e two motor cables should be close to the same length and bundled together as they run between
the controller and the motor. Keep the motor cables as short as possible. Use high quality copper lugs
and observe the recommended torque ratings. For best noise immunity, do not route the motor cables
across the center section of the controller. In applications that seek the lowest possible emissions,
place a shield around the bundled motor cables and connected to the B- terminal at the controller.
Typical installations will readily pass the emissions standards without a shield. Do not route the
low current wires parallel to the motor cables. To minimize noise coupling, route the low current
wires across the motor cables at a right angle. See Appendix B for EMC considerations in cable and
harness routing.
Bekijk gratis de handleiding van Curtis 1229, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Curtis |
| Model | 1229 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 19864 MB |
