Curtis 1226BL handleiding
Handleiding
Je bekijkt pagina 72 van 124
3 — PROGRAMMABLE PARAMETERS
Curtis Model 1226BL – July 2024 Return to TOC
pg. 64
MISC MENU
e following table describes the parameters on the Misc menu.
MISC MENU
PARAMETER
CAN INDEX
VALUES
DEFAULT
RAW VALUES
DATA SIZE DESCRIPTION
Password Enable
0x510000
Disable/Enable
Disable
0–1
8-bit
Indicates whether the feature to password-protect
parameter values is enabled.
The Password menu is visible when password protection
is enabled.
Restore Parameters
0x507601
−32768 − +32767
0
−32768 − +32767
16-bit
Resets all parameters to their factory default values. To
reset the parameters, specify any value except 1, then cycle
the keyswitch.
Update Supervisor
0x700101
0–1
0
0–1
16-bit
The primary microprocessor stores an image of the
supervisor microprocessor’s firmware. To use the image to
update the supervisor firmware, specify 1.
Drivers Setting Menu
e following table describes the parameters on the Drivers Setting menu.
DRIVERS SETTING MENU
PARAMETER
CAN INDEX
VALUES
DEFAULT
RAW VALUES
DATA SIZE DESCRIPTION
Coil Supply Enable
0x515400
Off/On
On
0–1
8-bit
Species whether the coil supply output is enabled.
If Off is specied, the Coil Supply output cannot be turned off if
the lift or lower driver shorts.
CAUTION: Specifying Off may make the system non-compliant
with EN 1175:2020 and may cause a higher probability of
dangerous failure. Regulatory compliance of the complete
vehicle system, including this setting, is the responsibility of the
vehicle OEM.
EM Brake Driver Checks Enable
0x341B01
Off/On
On
0–1
8-bit
Species whether the controller checks the driver for the
open condition:
On = If the open condition occurs, the controller opens the
driver and generates the EM Brake Driver Fault.
Off = The controller does not check for the open condition.
CAUTION: Specifying Off may make the system non-compliant
with EN 1175:2020 and may cause a higher probability of
dangerous failure. Regulatory compliance of the complete
vehicle system, including this setting, is the responsibility of the
vehicle OEM.
Pump Contactor Driver Checks
Enable
0x341C01
Off/On
On
0–1
8-bit
Species whether the controller checks the driver for the
open condition:
On = If the open condition occurs, the controller opens the
driver and generates the Pump Driver Fault.
Off = The controller does not check for the open condition.
CAUTION: Specifying Off may make the system non-compliant
with EN 1175:2020 and may cause a higher probability of
dangerous failure. Regulatory compliance of the complete
vehicle system, including this setting, is the responsibility of the
vehicle OEM.
Bekijk gratis de handleiding van Curtis 1226BL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Curtis |
| Model | 1226BL |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15971 MB |
