Handleiding
Je bekijkt pagina 14 van 69
8 • TS-70 and TSW-70 Series Touch Screens Security Reference Guide — Doc. 9216D
Before configuring 802.1X, perform the following tasks as necessary:
l
Unless server authentication is going to be disabled, the trusted x.509 certificate or certificates
that will be used to verify the 802.1X server’s certificate must be loaded into the device. Use the
certificate management commands to load the trusted certificates into the device. These may be
Root or Intermediate certificates. Refer to the Required Configuration on page 7 section for
instructions.
l
If EAP-TLS authentication is going to be used, a client certificate will be needed and must be
loaded into the device. Refer to the Required Configuration on page 7 section for instructions to
load a client certificate into the “machine” store.
Once 802.1X configuration is complete, restart the device to activate those settings. The device will try
to connect to the 802.1X network when it starts up.
802.1X Configuration
In order to configure and use 802.1X, various aspects of 802.1X will need to be configured, including
enabling it, setting up server authentication, and selecting a client authentication method. The following
commands are used for this configuration:
Enable 802.1X
To enable 802.1X, issue the following command:
8021xauthenticate [on/off]
l
on - 802.1X is enabled
l
off - 802.1X is disabled
l
No parameter - Displays the current setting
Example: 8021xauthenticate on
Set Trusted Server Certificates
Unless server validation will be disabled, the trusted certificates that 802.1X will use to verify the
server’s certificate must be indicated. The full list of trusted Root and Intermediate certificates loaded
into the device is not used for 802.1X—only the specific certificates selected by the 8021xtrustedcas
command are used. As indicated earlier, the trusted certificates must first be loaded into the device
using the standard Certificate Management commands.
The following commands can be used to list, add, and remove certificates from the list of certificates
that will be used by 802.1X.
List Certificates
To list available certificates, issue the following command:
8021xtrustedcas [list|listn|listu]
l
list - Shows all Root and Intermediate certificates for the device
l
listn - Shows all Root and Intermediate certificates for the device and also includes
identification number of each certificate
l
listu - Shows Root and Intermediate certificates that are used by 802.1X
Example: 8021xtrustedcas listn
Bekijk gratis de handleiding van Crestron TSW-770, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Crestron |
| Model | TSW-770 |
| Categorie | Monitor |
| Taal | Nederlands |
| Grootte | 5979 MB |