Crestron Green Light GLXX-2DIM8 handleiding

Niet gecategoriseerd

Crestron

24 pagina's

PDF beschikbaar

Handleiding

Crestron Green Light Express™ Dimming Panel

Appendix A: Setting Module Net IDs

The following procedure will normally be performed by an authorized Crestron representative as part of the System

Commissioning phase. For system wiring and basic testing as described on pages 10 and 14, it is not necessary to

perform this step. Only perform this step if instructed by an authorized Crestron representative, or when replacing

modules on a system that have already been commissioned (in the latter case the Net ID should be set to match the

Net ID of the module being replaced).

The Net ID of each module in the cabinet can be changed from the front panel of each module. The Net IDs of each

module in the system must be unique.

To set the Net ID using the front panel:

1. Press the recessed SETUP button to enter the Setup mode. The SETUP LED illuminates.

2. As shown in the following diagram, press the left button under the NET ID display to change the left digit

of the Net ID or press the right button under the NET ID display to change the right digit of the Net ID

number.

Changing the Net ID

CHANGES

LEFT DIGIT

CHANGES

RIGHT DIGIT

LABEL FOR

NET ID

SETUP

BUTTON & LED

RIGHT DIGITLEFT DIGIT

3. When the desired Net ID is displayed, press the SETUP button to exit the Setup mode. The SETUP LED

extinguishes.

If the SETUP button is not pressed, the Setup mode will time out after one minute of inactivity and the Net

ID will revert back to its original value.

Installation Guide – DOC. 6889B Crestron Green Light Express™ Dimming Panel • 19

Bekijk gratis de handleiding van Crestron Green Light GLXX-2DIM8, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.