Crestron Green Light GL-EXP-DIM-CN handleiding

Niet gecategoriseerd

Crestron

3 pagina's

PDF beschikbaar

Handleiding

GL-EXP-DIM-CN Dimmer Expansion Module, Cresnet

crestron.com

800.237.2041

LINE: (2) Captive screw terminals;

Line power feed input and pass-through;

24 to 10 AWG (0.25 to 4.0 mm

) wire size

DIM: (1) Captive screw terminal;

Dimmed load output;

24 to 10 AWG (0.25 to 4.0 mm

) wire size

N/C: (1) Captive screw terminal;

No connection (not used)

OVERRIDE: (2) Captive screw terminals;

Low-voltage contact closure sensing input;

Activates override mode when a closure is sensed;

26 to 14 AWG (0.14 to 1.5 mm

) wire size;

For use with Class 2 wiring only

CRESNET: (4) Captive screw terminals;

Cresnet slave port (communications only, does not use Cresnet power);

26 to 14 AWG (0.14 to 1.5 mm

) wire size;

For use with Class 2 wiring only

Ground: (1) 3-terminal grounding block

Controls & Indicators

PWR: (1) Green LED, indicates line power is applied to either LINE terminal

NET: (1) Yellow LED, indicates Cresnet network communication

ERR: (1) Red LED, indicates a variety of error conditions via blinking

patterns (refer to the installation guide)

ON/OFF: (1) Pushbutton and (1) red LED, pushbutton toggles the load

output on and off (press and hold to cycle the dimming level up and down),

LED indicates the load output is energized

RESET: (1) Pushbutton, initiates hardware reset

SW1: (1) Two-position slide switch (behind front cover), enables/disables

the zero-cross detection filter (disabled by default)

SW2 – SW4: (3) Two-position slide switches (behind front cover), not used

Environmental

Temperature: 32° to 104° F (0° to 40° C)

Humidity: 10% to 90% RH (non-condensing)

Construction

Enclosure: NEMA Type 1, galvanized steel with gray matte powder

coated removable front cover panel, extruded aluminum heat sink on rear,

(2) integral mounting flanges, (4) 1/2” or 3/4” conduit knockouts on bottom

and lower left & right sides

Mounting: Surface mount, must be oriented upright and mounted to a

vertical surface with 6 inches (153 mm) minimum spacing above and

below for proper ventilation and heat dissipation

Dimensions

Height: 8.78 in (223 mm)

Width: 6.39 in (163 mm)

Depth: 3.16 in (81 mm)

Weight

3.43 lb (1.56 kg)

Compliance

C(UL)US, UL 924, UL 2043, FCC Part 15 Class A commercial use

MODELS & ACCESSORIES

Available Models

GL-EXP-DIM-CN: Crestron Green Light

Dimmer Expansion Module,

Cresnet

Available Accessories

CRESNET: Cresnet

Control Cable

GLS-PLS-120/277: Power Loss Sensor

Notes:

This product may be purchased from an authorized Crestron dealer. To find a dealer, please

contact the Crestron sales representative for your area. A list of sales representatives is available

online at www.crestron.com/salesreps or by calling 800-237-2041.

The specific patents that cover Crestron products are listed online at: patents.crestron.com.

Certain Crestron products contain open source software. For specific information, please visit

www.crestron.com/opensource.

Crestron, the Crestron logo, Cresnet, and Crestron Green Light are either trademarks or registered

trademarks of Crestron Electronics, Inc. in the United States and/or other countries. UL is either

a trademark or registered trademark of UL LLC in the United States and/or other countries. Other

trademarks, registered trademarks, and trade names may be used in this document to refer

to either the entities claiming the marks and names or their products. Crestron disclaims any

proprietary interest in the marks and names of others. Crestron is not responsible for errors in

typography or photography. Specifications are subject to change without notice.

Bekijk gratis de handleiding van Crestron Green Light GL-EXP-DIM-CN, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.