Handleiding
Je bekijkt pagina 4 van 15
5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Retherm
Humidity Oven
FL-2392
Rev. 0 (5/16)
Page 4 of 15
OPERATING INSTRUCTIONS
FIRST-TIME OPERATION
NOTE: A new oven needs to “burn off” manufacturing
oils and excessive adhesive before its rst use. Do NOT
load food into oven until this has been done!
1. Push the switch to on; the light will come on.
NOTE: The letters “LOtPr” (low temperature) will show
on the control panel until it reaches 140°F (60°C).
2. Press the “COOK” button.
3. Turn the control knob to show 350°F. Push the knob 3
times to heat the unit. Run the unit like this for one
(1) hour.
4. Turn the unit off and let cool.
5. Wipe the inside clean with detergent and hot water.
HOW TO USE THE RETHERM CONTROL:
*Push the lighted switch on the control panel; the oven
will start heating and stay in HOLD mode.
*The display will read “LOTPR” (low temperature)
below 140°F. (60°C.).
*Push the Air Retherm Switch to “HIGH” for retherming
food; Use “LOW” for cooking.
NOTES: Preheat for one (1) hour after start up before
loading the food for best results when
retherming or cooking heavy loads.
If a power outage occurs or the cabinet is shut
off during a cook cycle, when it is turned on
again all lights on the control will ash to
indicate a disruption. Control will resume
the last cook cycle used. Press any button
to stop the blinking.
If your model does not have a food probe, continue to
section “-DE OVENS” below.
If your model has a food probe,
skip to section “-DX OVENS” on page 5.
-DE OVENS:
Cooking:
1. Press the COOK button.
2. Turn the control knob to the desired cooking
temperature between 180°F (82°C) and 350°F (176°C).
3. Push the knob to set the temperature.
4. The control automatically switches to allow you to set
HOLD temp. (Continue to step 1 below).
Holding:
(To use as holding cabinet only, skip steps 1-4 above and
press HOLD button. Complete steps 1-3 below.)
1. Turn the control knob to the desired holding
temperature between 135°F (57°C) and
220°F (104°C).
2. Push the knob to set the temperature.
3. The control automatically switches to allow you to set
cook time.
Setting the Timer:
1. Turn the control knob to the desired hours/minutes.
2. Push the knob to set the time.
3. The control automatically switches to PREHEAT
mode and will display “PrEHt”
Continued on next page.
NOTE: This equipment is intended for storage and display of packaged products only. Cold food cannot be
inserted for rethermalization while hot food is being held.
Bekijk gratis de handleiding van Cres Cor RR1332WDE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cres Cor |
| Model | RR1332WDE |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 4553 MB |
