Handleiding
Je bekijkt pagina 4 van 14
5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Retherm
Humidity Oven
FL-2356
Rev. 8 (2/15)
Page 4 of 14
OPERATING INSTRUCTIONS
HOW TO USE THE RETHERM CONTROL:
*Push the lighted switch on the control panel; the oven
will start heating and stay in HOLD mode.
*The display will read “LOTPR” (low temperature)
below 140°F. (60°C.).
*Push the Air Retherm Switch to “HIGH” for retherming
food; Use “LOW” for cooking.
NOTES: Preheat for one (1) hour after start up before
loading the food for best results when
retherming or cooking heavy loads.
If a power outage occurs or the cabinet is shut
off during a cook cycle, when it is turned on
again all lights on the control will ash to
indicate a disruption. Control will resume
the last cook cycle used. Press any button
to stop the blinking.
If your model does not have a food probe, continue to
section “-DE OVENS” below.
If your model has a food probe,
skip to section “-DX OVENS” on page 5.
-DE OVENS:
Cooking:
1. Press the COOK button.
2. Turn the control knob to the desired cooking
temperature between 180°F (82°C) and 350°F (176°C).
3. Push the knob to set the temperature.
4. The control automatically switches to allow you to set
HOLD temp. (Continue to step 1 below).
Holding:
(To use as holding cabinet only, skip steps 1-4 above and
press HOLD button. Complete steps 1-3 below.)
1. Turn the control knob to the desired holding
temperature between 80°F (26°C) and 220°F (104°C).
2. Push the knob to set the temperature.
3. The control automatically switches to allow you to set
cook time.
Setting the Timer:
1. Turn the control knob to the desired hours/minutes.
2. Push the knob to set the time.
3. The control automatically switches to PREHEAT
mode and will display “PrEHt”
Running the Cycle:
1. The control will ash “PUSH StArt” after the cabinet
has preheated to the set temp and the alarm will sound.
NOTE: A short beep will occur every 90 seconds as
a reminder. This can be turned off in the user menu by
holding the knob and the TIME buttons together for
5 seconds, then scrolling to “PSrE”, changing “y” to
“n”, scrolling to “End”, and pushing the knob to set.
2. Load foods into oven and close the door.
3. Push the START button to begin the Retherm/Cook
process. Display will change between the setpoint
temperature and the countdown of the timer.
4. The alarm will sound after the time is done and the
oven will switch back into HOLD mode. The timer
will now count up, showing how long the food has
been holding.
Bekijk gratis de handleiding van Cres Cor RO151FW1332DX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cres Cor |
| Model | RO151FW1332DX |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 4613 MB |
