Handleiding
Je bekijkt pagina 14 van 36
INSTRUCTION
MANUAL
14
Gas Connection
IMPORTANT: All gas installations must be carried out by a suitably qualified technician.
For information on choosing a gas safe installer, contact the Gas Safe Register.
www.gassaferegister.co.uk
WARNING: Before starting any work related with gas installation, turn off gas supply. Risk of explosion.
1. Before your appliance is connected to the gas supply, ensure that the gas category and pressure specifications
shown in the data plate corresponds with your gas supply. If necessary, call authorized service for adjusting to gas
category.
2. This appliance shall be installed in accordance with the regulations in force and only used in a well ventilated
space. Read the instructions before installing or using this appliance. In the interest of safety this appliance must be
installed and / or serviced by a competent person as stated in the gas safety regulations current editions.
3. The appliance must not be installed in a room without a window or other controllable opening. If is installed in a
room without a door which opens directly to the outside, a permanent opening is required. The air circulation should
be 2 m³/h per kW of burners.
4. The gas connection should be performed from the right or left. For this reason, change the hose nozzle, plug and
the seals.
5. Please use flexible hose for gas connection.
6. If you make a connection with a flexible metal hose, locate a seal between the main gas pipes.
7. The inner diameter of the flexible hose, which the butane hose nozzle is connected, should be 6 mm for the
house-type gas tubes. The inner diameter of the flexible hose, which the natural hose nozzle is connected, should be
15 mm. The hose should tightly be fitted to the hose nozzle by squeezing with a clamp. The hose should be replaced
before its last expiry date.
8. CAUTION: Make the oven connection to the gas inlet valve, the hose length must be short and be sure that there
is no leakage. The flexible hose used should not be longer than 125 cm for safety.
9. Re-inspect the gas connection.
10. When placing your oven to its location, ensure that it is at the counter level. Bring it to the counter level by
adjusting the feet if necessary.
WARNING: Do not make gas hose and electrical cable of your oven go through the heated areas, especially through
the rear side of the oven. Do not move gas connected oven. Since the forcing shall loosen the hose, gas leakage
may occur.
WARNING: The gas hose must not be clamped, bent are trapped or come into contact with hat parts of the product.
There is the risk of explosion due to damaged gas hose.
Reduce flame gas cock adjustment
1. Please use driver with special head for removed and install nozzle as (figure 3).
2. Please remove nozzle (figure 4) from burner with special nozzle driver and install new nozzle. (figure 5)
Bekijk gratis de handleiding van Creda C90RCDFCBL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Creda |
| Model | C90RCDFCBL |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 5516 MB |
