Handleiding
Je bekijkt pagina 13 van 36
INSTRUCTION
MANUAL
13
Electrical Connection
IMPORTANT: Electrical connections must be carried out by a suitably qualified person and in accordance with all
relevant local building and installation regulations.
Fitting on a Power Supply Cable
Connecting appropriate power supply ` terminal board/ connector block:
⚫
Using a screwdriver, prize open tabs of the Terminal board cover.
⚫
Remove the wire clamp screw.
⚫
Fasten
the
wires
beneath
the
corresponding
screw
heads,
using
brass
‘bridge’
for
single
phase
supply.
⚫
Fasten cable clamp and close the cover of the terminal board.
⚫
The ac power supply should be 220-240 V, 50/60 Hz. For electric cookers, the minimum 45A fuse, or at least 45A a
distribution circuit breaker.
Connecting the supply cable to the mains
Install an approved circuit breaker with a minimum contact opening of 3 mm, between the appliance and the mains
fuse box.The circuit breaker should be sized according to the load and should comply with current regulations (the
earth wire should not be interrupted by the circuit breaker).
The supply cable should be positioned so that it does not reach a temperature of more than 50℃ with respect to
the room temperature, anywhere along its length Before switching fuse ON in meter-box check:
⚫
Earth continuity. The electrical safety of this appliance can only be guaranteed if the cooker is correctly installed and
earthed, in compliance with regulations on electrical installations.
⚫
The electrical capacity of the system and sockets will support the maximum power of the appliance, as indicated on
the data plate.
Bekijk gratis de handleiding van Creda C90RCDFCBL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Creda |
| Model | C90RCDFCBL |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 5516 MB |
