Cooking Performance Group 351COHD4M handleiding

Oven

Cooking Performance Group

14 pagina's

PDF beschikbaar

Handleiding

. www.cookingperformancegroup.com

User Manual

Warning and Alarms

All alarms are indicated by a buzzer. The buzzer can be silenced by pressing a key.

• ERR = CHAMBER PROBE ALARM

This is triggered if the chamber probe fails. Everything is deactivated except for the light. The cycle in

progress is interrupted. Once the alarm is silenced, press the ON/OFF button for 1 second to reset the

alarm (the control panel is set to OFF).

• "ALL" = MOTOR ALARM

This is triggered if the motor overheats. Everything is deactivated except for the light. The cycle in

progress is interrupted. Once the alarm is silenced, press the ON/OFF button for 1 second to reset the

alarm (the control panel is set to OFF).

• "H-t" = CONTROL BOARD TEMPERATURE ALARM

This is triggered if the control board overheats. The cycle in progress is interrupted. Once the alarm is

silenced, press the ON/OFF button for 1 second to reset the alarm (the control panel is set to OFF).

Operator and Factory Parameters Table

Parameter Description

Default

Value

Limits Unit Level

P01 Temperature unit: 0=C, 1=F 0 0-1 Flag Operator

P03 Min. cooking temperature setpoint 30 30-200 C/F Factory

P06

Preheating superheating

(% value of the set above the cooking setpoint)

20 0-100 % Operator

P15

Light Mode: 0= timed on button pressure, 1= always

ON during cooking, 2= Always ON

2 0-2 Flag Operator

P16 Light activation time 45 0-120 Seconds Operator

P17 Enable Preheating 1 0-1 Flag Operator

P40 Default Setpoint for Cooling 50 30-70 C/F Operator

P52

Time of inactivity to switch to standy mode

(function disabled with 0)

10 0-60 Minutes Factory

Access the parameter menu with the oven set to "OFF", indicated by the top display of the

appliance. Press down the ‘ ’ key until the upper display shows "PAS" and the lower display shows "0",

ashing. Press the ‘+’ key to set the value shown on the lower display to "30". Conrm by pressing

START/STOP. The upper display will show the name of the parameter, whereas the lower one will show

the value of that parameter. Scroll through the list of editable parameters using the ‘+’ and ‘-’ buttons.

Once the parameter to be edited has been found, press the START/STOP button: the value shown on the

lower display will start to ash, and then press ‘+’ and ‘-’ buttons to change the value. Once the desired

value has been set, according to the table below, press START/STOP to conrm the change. When the

desired parameters have been changed, press the ‘ ’ key to set the appliance back to "OFF".

Bekijk gratis de handleiding van Cooking Performance Group 351COHD4M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.