Continental CPA68 handleiding

28 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 18 van 28
18
REFRIGERATED BASES & PIZZA PREP TABLES
OPERATIONS MANUAL
INSTALLING ELECTRIC CONDENSATE HEATER
The condensate heater has a thermal limit switch and power
cord attached. Remove the screws for the rear access panel
from the cabinet and set aside. Place the condensate heater in
the drain pan as shown in Figure 17. Position the end of the
plastic drain tube in the pan. Make sure tubing isn’t kinked, is
secure and doesn’t touch the heater. Plug the heater power cord
into the receptacle labeled “vaporizer”. Secure excess cord with
a wire tie, so it doesn’t fall into the pan or under the cabinet.
Reattach the access panel to the back of the cabinet.
IMPORTANT NOTE: It is extremely important to ensure
the condensate heater is plugged into the receptacle
labeled “vaporizer” and that the condensing unit is
plugged into the receptacle labeled “condensing unit.”
FIGURE 17: Electric Condensate Heater




















Using the small holes in the plate as a template, drill 1/8 pilot
holes in the bottom of the cabinet. (Note: drill only until you
penetrate the metal bottom of the cabinet. Do not continue
to drill into the insulation, or you may damage the cabinet.)
Secure the caster support plate assembly to the cabinet with a
sheet metal screw in each of the drilled holes. Tighten the 1/2”
bolts. Repeat these steps to attach the other plate assembly to
the opposite end of the cabinet.
Check that both plates are secure and that the casters turn
and swivel freely. Carefully lift the cabinet upright and double
check that the caster support plates are secure and the cabinet
is stable. Wait at least 3 hours before turning the refrigeration
system back on, and at least another 30 minutes for the cabinet
to come down to temperature and stabilize, before reloading
with product.
FIGURE 16: Caster Support Plates






Bekijk gratis de handleiding van Continental CPA68, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkContinental
ModelCPA68
CategorieNiet gecategoriseerd
TaalNederlands
Grootte5819 MB