Handleiding
Je bekijkt pagina 47 van 52
92 93
ENEN
Note:
• If the induction hob is switched o while the child lock function is activated, the control panel lock is active even
after the induction hob has been switched o. In this case the child lock is activated when the induction hob is
switched on and the “Lo” symbol is displayed on the control panel.
• For unlocking the control panel press and hold the symbol for activation/deactivation of the child lock (3) until the
acoustic sound goes o. The “Lo” symbol disappears and the control panel is active again.
Setting the cooking time (timer function)
1. Press the timer setting symbol during cooking. The „00“ value is blinking.
2. Set the required countdown time by pressing or moving your nger over the slider (1) in the range of 1- 99 minutes.
3. The countdown function starts within several seconds.
4. After the set time elapses, a sound signal is heard, which you can switch o by pressing a random symbol.
Note: To deactivate the countdown function, press the countdown symbol (5), then press or move your nger over
the slider (2) and set “00” on the display (4).
Hotzone delayed OFF function
1. Press the symbol for hotzone selection (2) to activate the hotzone. The power level is displayed on the respective
display of the hotzone.
2. Press the symbol of setting of the delayed OFF timer. Press or move your nger over the slider to set the delayed
switch-o time of the respective hotzone (1–99 minutes).
3. The delayed OFF function starts in several seconds (the remaining time is shining on the timer display and the
indicator of the selected hotzone is blinking).
4. After the set time elapses, asound signal is heard.
Note: The delayed OFF function can be set for one selected hotzone only. To deactivate the delayed OFF function,
set the timer to the “00” value. If you switch o the hotzone manually before the delayed OFF time elapses, the
setting of the delayed OFF timer is reset.
Delayed shut down function for multiple cooking zones
To set the delayed shut down for multiple cooking zones, proceed as in setting the delayed shut down of one cooking
zone.
The time shown on the display is the time of the hob, which has a dot next to the power digit.
Note:
• If the delayed shut down is only set for one cooking zone, only the cooking zone for which the delayed shut down
has been set is switched o after the set delay time has elapsed. Other cooking zones will remain on if no delayed
shut down is set for them.
• Delayed shut down can be set for a maximum of 99 minutes.
CARE AND CLEANING
The hob itself does not warm up, so no food remains should get burnt on it. Therefore, you do not have to wait until
it cools down to clean the hob.
Do not use a steam cleaner or high-pressure cleaner to clean the appliance. Risk of damage to the hob!
• Clean the hob with a protective and preservation agent specially designed for ceramic glass surfaces.
• For removal of food remains and other dirt, apply dirt repellent to the hob, which will facilitate cleaning of the
hob surface.
• Use only agents and repellents specially designed for ceramic glass surfaces.
• Never use coarse sponges, abrasive agents or aggressive cleaners (e.g. spray for cleaning ovens) or stain removers.
• Keep the control panel clean! Make sure the panel is always clean and dry.
• Food and water residues negatively aect the operation of the control panel; therefore it may not be fully
functional.
• Clean the hob after each cooking session. It will prevent the remains of food from burning during the next cooking
session.
• For cleaning the lukewarm hob use a cleaning agent and a paper towel. Then wipe the hob with a damp cloth and
wipe it dry using a soft cloth.
• If the hob is cleaned while hot, stains could appear on it.
• Never leave residues of the cleaning agent on the hob; it could stain the glass surface.
• Metallic-gloss colouring appears after the use of unsuitable cleaners or abrasion of the cookware bottom.
• Its removal is very dicult. Use cleaning agents specially designed for ceramic glass surfaces.
• For the removal of food remains and a layer of grease use a special scraper for the glass.
• Clean the hob by placing the scraper at an acute angle and move the blade on the surface. Never use the handle
for cleaning the glass surface. Risk of scratches!
• WARNING! The glass scraper is very sharp! Risk of injury! If the edge is damaged, replace it immediately.
• After cleaning, secure the scraper again and keep it out of the reach of children.
INSTALLATION INSTRUCTIONS
• The warranty does not cover damages caused by incorrect installation.
• The responsibility for installing the appliance lies with the buyer, not the manufacturer.
• The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation.
• To ensure the correct function of the appliance, place it in a suitable furniture.
• The appliance should be assembled into correct built-in units and work surfaces that align to the standards and
have dimensions shown in Fig. 7.
• The kitchen furniture must be made of suciently heat-resistant material, at least 120 °C. The materials and
adhesives used must be resistant to heat from the appliance as according to the CSN EN 60335-2-6 standard.
Materials and adhesives that do not meet the stated standard may deform or peel-o.
490
560
min. 50
min. 50
min. 50
Fig. 7
Bekijk gratis de handleiding van Concept IDV5760, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Concept |
| Model | IDV5760 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 5962 MB |
