Cleco NeoTek T55-3000021 handleiding
Handleiding
Je bekijkt pagina 9 van 32
Apex Tool Group P2407MA | 2019-06 9
1
EN
1 Product description
As an accessory for NeoTek tools, the Gyroscope allows the angular correction of handheld tools without
support.
Until now, a support has been needed for angle-controlled sequences. As a result, any change in the refer-
ence angle during final tightening, e.g., because of an evasive movement by the worker, should be avoided.
The gyroscope makes such a support unnecessary.
2 Use
3 Installation
30/50/70ESN(…), 30/50/70EAN(…)
• First accessory: see Figure 01, Page 3
• Second accessory (optional): see Figure 02, Page 3
30/50EPN(…)
• First accessory: see Figure 03, Page 4
• Pistol suspension bail (optional): see Figure 04, Page 4
4 Activating accessories
For additional settings, see the particular software documentation for the controller.
Gyroscope
Order No.
942396PT 943684PT 943685PT T55-
3000020
T55-
3000021
Requirements
NeoTek tool 30 Series... 50 Series... 70 Series... 30 Series... 50 Series...
Angle head,
inline
Angle head,
inline
Angle head,
inline
Pistol Pistol
Software requirements
Bootloader: S169353-101 or later
Controller: e.g., S168813-1.9 or later
Measurement card: S168025-510 or later
TIM (Tool Interface Module): 3.4
Note
Note the order of the software updates:
1. Perform controller software update.
2. Perform measurement card firmware update.
3. Perform TIM firmware update.
4. Perform firmware update for accessories.
Note
Before installing, take the tool out of operation or switch off the controller.
Bekijk gratis de handleiding van Cleco NeoTek T55-3000021, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cleco |
| Model | NeoTek T55-3000021 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2577 MB |
