Cleanmaxx 16382 handleiding
Handleiding
Je bekijkt pagina 16 van 20

EN
16
Nozzles
• Attaching: Slide the nozzle(15 or 16)
onto the spraying handle(12). The nozzle
release button(14) must engage.
• Detaching: Press the nozzle release
button and pull the nozzle off.
• To clean the brush nozzle(16), the
transparent cover can be removed.
FILLING THE
FRESH WATER TANK
1. Remove the fresh water tank(clean
water
)
(10) from the device and
open it (see the “Attaching and Detach-
ing Accessories” chapter).
2. Fill with clean water (max. 40°C) and
cleaning agent if necessary .
Do not
exceed the MAXmarking
!
3. Close and insert the fresh water tank.
USE
Please Note!
■ Note the MAX marking on the dirty
water tank (dirty water
)
. Do not
exceed it to prevent the motor from
being overloaded.
■ Empty the dirty water tank regularly,
but whenever the MAXmark is
reached
(see the “Cleaning the Device”
chapter).
■ Place the device on a waterproof
surface.
■ Clean the filters(2, 6) regularly to pre-
vent the motor from being overloaded.
Replace if necessary.
L
If you use the device with clean-
ing products, there may be some
foaming beneath the device.
This does not constitute a defect
and is harmless.
Preparation
• Remove coarse dirt with astandard
vacuum cleaner.
• If there is a lot of dirt, spray additional
cleaning agent onto the surface to
be cleaned and spread it around with
a brush if necessary. It is essential to
follow the instructions on the bottle of
thecleaning agent.
• Attach the required accessories (see the
“Attaching and Detaching Accessories”
chapter).
• Make sure that the fresh water tank(10)
is filled (see the “Filling the Fresh Water
Tank” chapter) and both tanks are
inserted in the motor unit.
Operation
• Switch on / off:
Press the button(4).
• Spraying (PictureD): Press the spray
button(13) on the spraying handle and
moisten the surface to be cleaned.
• Scrubbing: Use the brush nozzle(16)
and gentle pressure to scrub the surface
to be cleaned.
• Suction: Pull the nozzle opening with
gentle pressure over the surface to be
cleaned. The liquid is collected in the
dirty water tank(17).
• When the fresh water tank is empty or
the dirty water tank is full, switch off the
device. Only after this should you fill
or empty the appropriate tank (see the
“Cleaning the Device” chapter).
L
Place the nozzle on a cloth as resid-
ual water may escape after it has
been switched off.
Bekijk gratis de handleiding van Cleanmaxx 16382, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | Cleanmaxx |
Model | 16382 |
Categorie | Stofzuiger |
Taal | Nederlands |
Grootte | 1730 MB |