Cicada Audio CH65.4V2 handleiding
Handleiding
Je bekijkt pagina 6 van 18
INSTALLATION
Installing the Speakers
Your new Cicada Audio CH series speakers were designed with the flexibility to be installed in multiple Locations.
However, to ensure the best performance possible, it is important to isolate the front sound waves of the speaker
from its rear sound waves. This is done by securely mounting the speaker to a flat surface known as a baffle. Make
sure to seal the speaker to ensure there are no air leaks around its frame. Screws are NOT included, as these are
installed totally into custom installs....and we know how you guys (and gals) are!
Selecting a Location
These are “Pro Drivers” ...AND we know the likelihood of mounting in stock locations is typically pretty non-existent.
But THESE particular drivers are light weight and relaitivly shallow so they can be used in a LOT of different applica-
tions. But follow good audio practices...
We HIGHLY recommend that for the BEST sound you put a sound deadening mat on the door “skin”,fairing or bag,
The more “damped” your vehicle/bike is.... the better.... it will ultimately sound!!!
Remember that the Midrange driver is 4 Ω (or 2Ω) and the Tweeter is 8 Ω . These drivers were especially
designed for Motorcycles but can be used in cars, trucks, boats and UTVs as the cones are UV and water resis-
tant. They are light weight and extremely efficient. Great for a lot of applications.
SYSTEM DESIGN - PASSIVE
TYPICAL SYSTEM USING
INCLUDED PASSIVE CROSSOVERS
CH69.4 / CH69.2
The Cicada Audio CoAx Horn drivers comes with
a special 12dB per octave crossover. It is HIGHLY
recommended that this be used at ALL times -
UNLESS you are using an active crosssover set
+
CH SERIES COAX TWEETER
12dB PER OCTAVE
at above 4kHz.This system, shown is run off the
HIGH-PASS FILTER
+
(INCLUDED)
Front channels of this 4 channel amplifier are driving
the CH65.4 Pro CoAx Horn drivers. Rear channel
are driving the CH69.4 Pro CoAx Horn drivers
(ONLY One Side - RIGHT- is shown)
+
LEFT FRONT & LEFT REAR
“OPTIONAL”
(CH 1 & 3)
TWEETER ATTENUATION
CH65.4 / CH65.2
CH3(RL -) CH3(RL +)
CH1 CH2 +
CH3 CH4 +
+12V REM GND
DSP125.4D
PWR
/DSP150.4D
PRT
+
CH1 + CH2 CH3+ CH4
4 CHANNEL
BRIDGED BRIDGED
SPEAKER OUTPUT
AMPLIFIER
+
+
CH1(FL -)
CH1(FL +)
4 Ohm resistor
RIGHT FRONT AND RIGHT REAR (CH 2 & 4)
INCLUDED
ARE NOT CONNECTED IIN THIS DRAWING
2021 Cicada Audio All rights reserved.
5
Bekijk gratis de handleiding van Cicada Audio CH65.4V2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cicada Audio |
| Model | CH65.4V2 |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 11244 MB |
