Chiq WFL85T48W2 handleiding
Handleiding
Je bekijkt pagina 29 van 32
Troubleshooting
28
Problem
Possible cause / solutions
The water level is too low
when the machine is
washing
This is not a fault. The water consumption in wash cycle of this appliance is
relatively little, the water level in wash cycle is lower than other type
washing machine normally.
Make up water during
wash cycle operation
If the water level drops, the machine will make up water automatically.
When the amount of washing clothes is too large, the appliance may make
up water automatically several times during wash cycle operation.
There is too much foam in
drum or the foam overflow
from detergent dispenser
The detergent is not suitable for machine washing (it should display the text
“for washing machines” or “hand and machine wash” or the like).
Too much detergent was used – less detergent is required in soft water.
The high-speed spinning
needs to be repeated many
times
Due to the different types and materials of the laundry, the load balancing
system of the appliance may wobbling and dispersing the clothes for many
times to prolong the spinning time. This is a normal phenomenon, not a
machine failure.
The machine does not spin
The Spin Speed is turn off by setting the spin speed to “－－”.
The machine vibrates a lot
during the spin cycle
The feet have not been adjusted, enabling the machine to rock.
New Installation – Either the Transit Bolts including the plastic spacer, or the
Polystyrene Packaging have not been removed when installing the machine.
The appliance is trapped between cabinets and/or walls.
The load is in a slight out of balance condition and the appliance is spinning,
but at a lower speed.
The spin effect is not ideal.
When washing less clothes, such as a pair of jeans, a sweater, a bath towel,
etc., the machine may not complete the spinning process due to balance
protection.
If the load is in a slight out of balance condition and the appliance is
spinning, but at a lower speed, not at the default spin speed of the cycle or
the spin speed setting for the cycle.
The machine does not
drain , drains slow or “E03”
appears in the display
The top of the drain hose is too high – It must be fitted at a height between
65 and 100 cm from the floor。
The pump filter is blocked.
The drain hose is kinked , twisted or bended.
The drain hose is blocked or frozen.
The program time stops
counting down before
entering high-speed
spinning process
This is not a fault. The load balancing system of the appliance wobbling and
dispersing the clothes in the drum for a long time to achieve balance and
complete high-speed spinning; In the process of wobbling and dispersing,
the program time stops counting down before the appliance entering
high-speed spinning process.
The program takes too long
Program times will vary due to water pressure, the incoming water
temperature and if the wash load goes out of balance. This will increase the
program times accordingly (see “The high-speed spinning needs to be
repeated many times” ).
The machine is noisy
There will always be some motor, pump and drum noise during spin.
The washing machine touches other objects.
The foreign matters such as hairpins or metal objects fall in drum or tub.
Bekijk gratis de handleiding van Chiq WFL85T48W2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Chiq |
| Model | WFL85T48W2 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 5679 MB |
