Chiq WFL85T48W2 handleiding
Handleiding
Je bekijkt pagina 28 van 32
Troubleshooting
27
Your appliance could occasionally fail to work. Before contacting the service center, make sure that the problem
cannot be solved easily using the following list.
Problem
Possible cause / solutions
There are color spots and
oil stains in the drum
The appliance requires a service wash. Run a “Drum Clean” wash cycle with
no detergent and no laundry.
The machine smells
Due to the use of rubber parts, the machine will have rubber smell at the
beginning of use, but the rubber smell will gradually disappear during use.
The door cannot be opened
The safety protection function is in operation, and the water temperature
and/or water level are/is too high.
Whether the program has ended normally and whether there is power
failure.
Is the child lock function activated? Turn off the child lock function.
Whether to select the delay end function? Turn off the delay end function.
The machine leaks from the
dispenser
The dispenser drawer is blocked with detergent and requires cleaning.
The water pressure is too high and requires turning down – turn down the
tap on the water supply pipe slightly and try again.
The appliance is tilting forwards – It must be level when in its final position.
The machine leaks (other
than dispenser)
The water inlet hose is loose, check both the cabinet and tap ends .
The inlet hose is tight but still leaks, if so replace the rubber washers, or the
water inlet hose is missing the rubber washer.
The drain hose is not fixed in properly.
In case of water leakage inside the machine, please turn off the power
supply and contact the after-sales department for maintenance
The machine does not
swtich on
The appliance is not plugged into the socket fully, or not enough to make
contact.
There is not power to the socket, or the fuse has blown in the mains plug.
The wash cycle does not
start
The door is not closed properly.
The POWER button has not been pressed.
The START/PAUSE button has not been pressed.
The water tap has not been turned on to allow water to flow into appliance.
A Delay end function has been set.
The machine does not fill
with water, the detergent
cannot flow into the drum
or “E02” appears in the
display
The water inlet hose is kinked, twisted and bent.
The water inlet hose is not connected to the water supply.
The water pressure is too low.
The water tap has not been turned on to allow water to flow into the
machine.
There is no water supply to the house.
The mesh filter in the water inlet hose and/or water inlet valve are/is
blocked.
The faucet and/or water supply pipe are/is frozen.
The delay end function is selected so that the machine does not enter water
The START/PAUSE button has not been pressed.
There is enough water in the drum already.
Discharge the water when
the program is started
This is not a fault. Please do not open the door to pour the water directly
into the drum before the program runs, otherwise the machine may
discharge the water which has been poured into the drum when the
program is started,
Bekijk gratis de handleiding van Chiq WFL85T48W2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Chiq |
| Model | WFL85T48W2 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 5679 MB |
