Chief DVM27U2E handleiding
Handleiding
Je bekijkt pagina 22 van 24
DVM27U Series Installation Instructions
22
Fastener Installation Methods
IMPORTANT ! : See Table 1 for appropriate hardware
and pilot hole sizes for various wall types.
IMPORTANT ! : The expanse of the LED wall will most
likely mean that attachment of the wall mounts will not all
be in studs. The attachment method will most likely vary
throughout the installation, and more than one of the
various methods outlined here will most likely be used.
Wood Stud/Steel Stud (w/plywood backing)
IMPORTANT ! : The DVM72U LED wall mounts are
designed to be mounted to a 3/4" thickness plywood-
backed, 2" x 4" wood studs (16" on center minimum) wall
with a maximum drywall thickness of 5/8" or a 3/4"
thickness plywood-backed, steel stud wall covered with
drywall having a maximum thickness of 5/8".
1. Use one 5/16" x 2-1/2" hex flange head lag bolt (CA) and
5/16" washer (CE) through product and into pilot hole. (See
Figure 31)
2. Repeat for remaining pilot holes.
Figure 31
Concrete or Concrete Block
IMPORTANT ! : The DVM27U LED wall mounts are designed
to be mounted to a bare 8" concrete or 8"x8"x16" concrete
block wall.
1. Install one UX10X60R anchor (CF) into each pilot hole
using a hammer, making sure that the anchor is flush with
the wall. (See Figure 32)
2. Use one 5/16" x 2-1/2" hex flange head lag bolt (CA) and
5/16" washer (CE) through product into each anchor in wall.
(See Figure 32)
3. Repeat for remaining pilot holes.
Figure 32
1
2
(CA)
(CE)
1
2
(CA)
(CF)
(CE)
Bekijk gratis de handleiding van Chief DVM27U2E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Chief |
| Model | DVM27U2E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3836 MB |
