Champion 11008 handleiding
Handleiding
Je bekijkt pagina 14 van 15
11008 - 10,000 LB. WINCH
TROUBLESHOOTING
14
TROUBLESHOOTING
Problem Cause Solution
Motor does not turn on.
Switch assembly not connected
properly.
Insert switch assembly all the way into the
connector.
Loose battery cable connections. Tighten nuts on all cable connections.
Contactor malfunctioning.
Tap contactor to loosen contacts. Apply 12
volts to coil terminals directly. A clicking
indicates proper activation.
Defective switch assembly. Replace switch assembly.
Defective motor.
Check for voltage at armature port with
switch pressed. If voltage is present,
replace motor.
Water has entered motor.
Allow to drain and dry. Run in short burst
with load until completely dry.
Motor runs but cable drum does
not turn.
Clutch (cam ring) not engaged.
Move cam ring to the “In” position.
If problem persists, a qualified technician
needs to check and repair.
Motor runs slowly or without
normal power.
Insufficient current or voltage.
The battery is weak, recharge. Run winch
with vehicle motor running (battery should
have a strong charge).
Loose or corroded battery cable
connections.
Clean, tighten, or replace.
Motor overheating. Winch running time too long. Allow winch to cool down periodically.
Motor runs in one direction only.
Defective or stuck contactor.
Tap contactor to loosen contacts.
Repair or replace contactor.
Defective switch assembly. Replace switch assembly.
For further technical support:
Technical Support Team
Toll Free 1-877-338-0999
support@championpowerequipment.com
Bekijk gratis de handleiding van Champion 11008, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Champion |
| Model | 11008 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1919 MB |
