Cecotec Bolero Hexa C126001 Line A Handleiding (208 Pagina's)

Handleiding

/ 208

Je bekijkt pagina 54 van 208

BOLERO HEXA C126001 LINE A

BOLERO HEXA C126001 GLASS BLACK A

54

ENGLISH

- To ensure adequate ventilation, the rear panel of the cabinet must be removed. It is

preferable to install the oven so that it rests on two wooden slats. If the oven rests on a

at surface, there must be an opening of at least 45×560 mm.

- Adjacent cabinet panels shall be made of heat-resistant material. In particular, enclosures

with veneered exteriors must be assembled with glues that can withstand temperatures

up to 100 °C.

- In compliance with current safety regulations, it must not be possible to come into contact

with the electrical parts of the oven once it has been installed.

- All parts that ensure the safe operation of the appliance must only be removed with the

aid of a tool (NOT INCLUDED).

- To x the oven to the cabinet, open the oven door and x it by inserting the 4 wood screws

into the 4 holes on the perimeter of the frame. Fig. 3

Electrical connections

Ovens equipped with a three-pole power cable are designed to operate on alternating current.

The cable for the grounding of the device is yellow green.

Mounting the power cable

Opening the terminal box. (Fig. 4):

1. Use a screwdriver to pry the bolt on the side tabs of the terminal box cover.

2. Unscrew the screw and open the cover.

3. To install the cable, proceed as follows:

4. Remove the cable clamp screw and the three contact screws.

5. Fix the wires under the screw heads using the following colour scheme:

- Blue - Neutral (N)

- Brown - Phase (L)

- Yellow - Green (Ground)

6. Secure the power cable with the cable clamp and close the terminal box cover.

Open the terminal box

3. With a screwdriver, tighten the screw on the side tabs of the terminal box cover.

4. Unscrew the screws on the side tabs of the cover and remove the latter.

Connecting the power cable to the mains

- Install a standard plug (not included) corresponding to the load indicated on the rating

plate. When connecting the cable directly to the mains, install an omnipolar circuit

breaker with a minimum contact opening of 3 mm between the device and the mains.

The omnipolar circuit breaker must be sized according to the load and comply with the

applicable regulations (the earth wire must not be

- interrupted by the circuit breaker).

04720_04721 Bolero Hexa C126001 Line A_GlassBlack.indd 5404720_04721 Bolero Hexa C126001 Line A_GlassBlack.indd 54 26/4/24 9:4126/4/24 9:41

/ 208

Bekijk gratis de handleiding van Cecotec Bolero Hexa C126001 Line A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.