Cecotec Bolero DressCode 7610 Inverter A Handleiding (492 Pagina's)

Handleiding

/ 492

Je bekijkt pagina 134 van 492

BOLERO DRESSCODE 7610 / 8610 / 9610 / 10610 INVERTER A

134

ENGLISH

To access the drain pump lter, you must rst open the cover on the bottom right-hand side.

Press lightly to open the lid (Fig. 22). With the lid open, proceed as follows:

1. If the appliance has not been drained, try draining it now. First, turn the wash cycle knob

to select the “SPIN” programme, press the “SPEED” button until the display shows “-”, then

press the “START/PAUSE” button. Wait a moment for the pump to drain the water from the

drum. If the pump is totally blocked, the water will not be able to drain, and the cycle will

end.

2. Turn o the tap so that no more water enters. Switch o the appliance. Disconnect the

power cord from the plug.

3. Use the removable drain hose located on the lter access opening to drain the remaining

water into a suitable container (up to 20 litres of water can be drained). Remove the plug

from the hose and place it over the side of a suitable container and allow the water to drain

out of the drum. When nished, replace the sealing plug on the end of the hose and return

the hose to its storage location. Be careful not to spill the drained water on the oor (Fig.

23).

4. Turn the lter cover counterclockwise to remove the lter. A small amount of residual

water may ow out when the lid is removed. Clean the inside, as well as the lter itself,

removing any debris or foreign objects. Remove any lint, dirt or detergent residue from the

lter thread. You can use water, a cloth or a soft brush. Reinstall it in its original position

(Fig. 24).

5. Close the lid and wipe up any water spillage (Fig. 25).

6. TROUBLESHOOTING

Problem Cause and possible solution

There are coloured stains

and oil stains on the drum

The appliance requires a service wash. Run a DRUM CLEAN

wash cycle without detergent and laundry.

Bad smells Due to the use of rubber parts, the machine will have a

rubber smell at the beginning of use, but the rubber smell will

gradually disappear during use.

Leave the door ajar after each wash cycle.

The door cannot be opened The safety protection function is in operation and the water

temperature and/or water level are too high.

If the programme has nished normally, but there is a power

failure.

Is the CHILD LOCK function activated? Deactivate the child lock

function.

Turn o the delayed end function.

/ 492

Bekijk gratis de handleiding van Cecotec Bolero DressCode 7610 Inverter A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.