Cecotec Bolero DressCode 6150 handleiding

Wasmachine

Cecotec

215 pagina's

PDF beschikbaar

Handleiding

/ 215

Je bekijkt pagina 55 van 215

BOLERO DRESSCODE 6150 INVERTER A

BOLERO DRESSCODE 7150 INVERTER A

BOLERO DRESSCODE 7150 INVERTER STEEL A

BOLERO DRESSCODE 6150 INVERTER A

BOLERO DRESSCODE 7150 INVERTER A

BOLERO DRESSCODE 7150 INVERTER STEEL A

109108

ENGLISH ENGLISH

Vertical adjustment

By applying downward force on the washing machine, the washing machine should not shake

(both diagonals should be checked, if the washing machine shakes, the adjustable feet should

be readjusted).

Figure 11

Locking and unlocking the door

Door locking

- After starting the appliance, the door will automatically lock, and the Door lock indicator

light will light up on the control panel.

NOTE: when pressing the Start/Pause button, it is normal to hear the “click” sound of the door

locking, this is not a fault.

If any error code appears, press the Start/Pause button twice to continue running the washing

programme.

Door unlocking

- When the Door lock indicator light lights up on the control panel, press Start/Pause, the

drum will stop operating. Wait a few seconds, the door lock will automatically deactivate,

and the indicator light will switch o.

- NOTE: for security reasons, it may take several minutes for the door to unlock.

- ATTENTION: foam will overow if you open the door in the middle of a washing cycle. If this

happens, use a towel to clean it.

- If the water temperature is too high, the door will not open during operation.

- If the water level is too high, the door cannot be opened during operation.

4. OPERATION

- Washing cycle times can be altered by many factors such as water pressure, weight and

type of fabric, water temperature, etc.

- During the operating cycle, the wash and spin time may be dierent from the actual run

time.

- During the washing cycle, the time shown on the display will vary according to multiple

factors.

- If the spin speed is too low, the rinsing eciency may be reduced.

by opening the taps. If water leaks, recheck steps 1 to 4.

Fig. 9 key:

1. Water inlet

- The washing machine is designed for domestic use, do not install it on a ship or caravan.

- Please, close the tap if it is not going to be used for a long time

- (e.g. holidays).

- Remove the plug and cancel the door lock function to prevent children from locking

themselves inside.

- Packaging materials (e.g. plastic, foam) can damage the child’s safety and cause

suocation.

Warning: PLACE ALL PACKAGING MATERIALS OUT OF THE REACH OF CHILDREN.

Installing the drain hose

- Secure the drain hose with a rope, wire, cable tie or similar item.

- To avoid damage caused by leakage to the oor, position the drain hose correctly.

- The height of the drain hose should be between (0.85 m - 1.25 m) above, the terminal

should not be placed directly in the water.

- If the drain hose is too long, do not force it to insert it into the appliance, as this will cause

abnormal noise.

Please, check Fig. 10 below.

Fig. 10 key:

1. Sink

2. Hose bracket (not included)

3. Wire (not included)

Horizontal adjustment

To avoid noise and vibrations by adjusting the washing machine level:

- Preferably place it in the corner of the room.

- If the oor is not level, straighten with the adjustable feet. Do not place pieces of wood or

the like, make sure that all four adjustable feet touch the oor rmly and that the appliance

is completely levelled.

Adjusting the adjustable feet

Adjust the adjustable feet to ensure that the washing machine is levelled and that it can be

placed rmly on the oor. After adjustment, screw on the locknut to secure. To prevent the

machine from falling down, do not place it on a platform that is higher than the oor.

/ 215

Bekijk gratis de handleiding van Cecotec Bolero DressCode 6150, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.