Cecotec Bolero DressCode 10900 Inverter A handleiding

Wasmachine

Cecotec

400 pagina's

PDF beschikbaar

Handleiding

/ 400

Je bekijkt pagina 122 van 400

BOLERO DRESSCODE 10900 INVERTER FULLCOLOR A

BOLERO DRESSCODE 10900 INVERTER FULLCOLOR STEEL A

BOLERO DRESSCODE 10900 INVERTER FULLCOLOR ICE BLUE A

122

ENGLISH

3. Now unscrew the water supply hose at the back of the appliance by hand. Remove

the mesh lter from the water inlet valve at the back of the appliance with needle-

nose pliers (be careful not to damage it) and clean it carefully (Fig. 21).

4. Reinsert the mesh lter back into the back of the washing machine. Reconnect the

water supply hose to the tap and to the appliance. Do not use a tool to connect the

inlet hose. Open the water tap and check that all connections are tight (Fig. 22).

Cleaning the drain pump lter

WARNING: DANGER OF BURNS. Danger of skin injury from hot water!

Take special care when draining water from the appliance and opening the lid.

It is advisable to clean the lter of the drain pump from time to time to ensure that there

are no problems.

The pump of the appliance may become blocked with loose debris (remember to check the

drum and remove visible debris after each load). Fabrics that shed large amounts of lint

can also cause blockages.

To access the drain pump lter, you must rst open the cover on the bottom right-hand

side. Press lightly to open the lid (Fig. 23). With the lid open, proceed as follows:

1. If the appliance has not been drained, try draining it now. First, turn the washing cycle

knob to select the SPIN programme, press the SPEED icon until the display shows “-”,

then press the START/PAUSE icon. Wait a moment for the pump to drain the water

from the drum. If the pump is totally blocked, the water will not be able to drain, and

the cycle will end.

2. Turn o the tap so that no more water enters. Switch o the appliance. Disconnect

the power cord from the plug.

3. Use the removable drain hose located on the lter access opening to drain the

remaining water into a suitable container (up to 20 litres of water can be drained).

Remove the plug from the hose and place it over the side of a suitable container and

allow the water to drain out of the drum. When nished, replace the sealing plug on

the end of the hose and return the hose to its storage location. Be careful not to spill

the drained water on the oor (Fig. 24).

4. Turn the lter cover counterclockwise to remove the lter. A small amount of residual

water may ow out when the lid is removed. Clean the inside, as well as the lter

itself, removing any debris or foreign objects. Remove any lint, dirt or detergent

residue from the lter thread. You can use water, a cloth or a soft brush. Reinstall it

in its original position (Fig. 25).

5. Close the lid and wipe up any water spillage (Fig. 26).

/ 400

Bekijk gratis de handleiding van Cecotec Bolero DressCode 10900 Inverter A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.